Abstract:Phase change material has become a research hotspot in the field of passive thermal management for lithium-ion batteries due to its low price and high latent heat. However, the low thermal conductivity limits the thermal efficiency of thermal management system. In this paper, the graphite powders/paraffin binary composite with a superior ratio suitable for battery thermal management was prepared, and the ternary composite was obtained by introducing nickel foam. The temperature fields during melting were visually observed through thermal imaging, and the influence mechanism of graphite powders and nickel foam on the movement pattern of the phase transition interface was investigated through comparative experiments. The results showed that the addition of nickel foam significantly accelerated the pushing rate of the phase transition interface in the lower and middle regions. The temperature difference along the height direction of both paraffin and binary composite increased with the increase of distance from the heating surface, while that of ternary composite showed no significant correlation with the distance. At a distance of 75 mm from the heating surface, the maximum temperature difference along the height direction of the ternary composite was 47.58 % and 25.43 % lower than that of the paraffin and binary composite, respectively. This paper also discussed the recovery periods for the thermal storage capacity of phase change materials. The ternary composite was the fastest to recover its thermal storage capacity, with its recovery period being 22 % shorter than that of the other materials. It also exhibited the best temperature uniformity. Its maximum temperature difference was 28.77 % lower than that of the other materials.

Thermal conductivity measurement of phase-change material near melting point based on perturbation method

A New Model of Phase Change Process for Thermal Energy Storage

A Novel Indirect Visualization Method for Studying the Melting Heat Transfer of Nano-Enhanced Phase Change Materials Using Thermochromic Liquid Crystal Thermography

Transient Performance of a Thermal Energy Storage-Based Heat Sink Using a Liquid Metal As the Phase Change Material

Combined measurement and calibration method for the thermal conductivity of phase change materials

Transient Determination on the Bulk Thermal Conductivity of Sub-Millimeter Thin Films of Composite Phase Change Thermal Interfacial Materials

Investigation on the Melting Performance of a Phase Change Material Based on a Shell-and-Tube Thermal Energy Storage Unit with a Rectangular Fin Configuration

Numerical investigations of melting process with sidewall heating under various control parameters

A Novel Method for Determining the Melting Point, Fusion Latent Heat, Specific Heat Capacity and Thermal Conductivity of Phase Change Materials

Melting Performance Enhancement of Phase Change Material with Magnetic Particles under Rotating Magnetic Field

Performance Enhancement of Latent Thermal Energy System under Alternating Magnetic Field

Metrology based on transient heat transfer theory for evaluating phase change materials with differential scanning calorimetry

Sensitivity Analysis Of Thermophysical Properties On Pcm Selection Under Steady And Fluctuating Heat Sources: A Comparative Study

Theoretical study on melting of phase change material by natural convection

A simple method, the -history method, of determining the heat of fusion, specific heat and thermal conductivity of phase-change materials

Experimental investigation of thermal performance in a shell-and-tube phase change thermal energy storage unit with an inner square tube

Determination on the thermal conductivity and thermal contact resistance of thin composite phase change films as a thermal interfacial material

Composition Dependent Phase Transition and Its Induced Hysteretic Effect in the Thermal Conductivity of Wxmo1-Xte2

A novel model for calculating the melting process of composite phase change materials

Phase equilibria -- thermal conductivity relationship within multicomponent Phase Change Materials from 273 K up to above the melting temperature

Experimental study on heat transfer characteristics of graphite powders based composite phase change materials