Abstract:The aim of this paper is to study the influence of enclosure size in latent heat thermal energy storage systems embedded in a porous medium for domestic usage of latent heat thermal energy storage heat exchangers. A 2-D rectangular enclosure is considered as the computational domain to study the heat transfer improvement for a phase change material embedded in a copper foam considering a constant heat flux from the bottom surface. Different dimensions of the composite system are examined compared with a system without a porous medium. The thermal non-equilibrium model with enthalpy-porosity method is employed for the effects of porous medium and phase change in the governing equations, respectively. The phase change material liquid fraction, temperature, velocity, stream lines and the rate of heat transfer are studied. The presence of a porous medium increases the heat transfer significantly, but the improvement in melting performance is strongly related to the system's dimensions. For the dimensions of 200 × 100 mm (W × H), the melting time of porous-phase change material with the porosity of 95% is reduced by 17% compared with phase change material-only system. For the same storage volume and total amount of thermal energy added, the melting time is lower for the system with a lower height, especially for the phase change material-only system due to a higher area of the input heat. The non-dimensional analysis results in curve-fitting correlations between the liquid fraction and Fo.Ste.Ra −0.02 for rectangular latent heat thermal energy storage systems for both phase change material-only and composite-phase change material systems within the parameter range of 1.16 < Ste < 37.13, 0 < Fo < 1.5, 2.9 × 10 4 < Ra < 9.5 × 108, 0 < L f < 1 and 0 < Fo.Ste.Ra −0.02 < 0.57. Over a range of system's volume, heat flux and surface area of the input heat flux, the benefit of composite phase change material is variable and, in some cases, is negligible compared with the phase change material-only system.

A novel model for calculating the melting process of composite phase change materials

A New Model of Phase Change Process for Thermal Energy Storage

STUDY ON CHARGING AND DISCHARGING RATES OF LATENT HEAT THERMAL ENERGY STORAGE SYSTEMS EMPLOYING MULTIPLE PHASE CHANGE MATERIALS

Preparation and Properties of Paraffin /LDPE /OMMT /graphite Phase Change Composite for Thermal Energy Storage

Heat transfer during melting of graphene-based composite phase change materials heated from below

A Novel Indirect Visualization Method for Studying the Melting Heat Transfer of Nano-Enhanced Phase Change Materials Using Thermochromic Liquid Crystal Thermography

Theoretical study on melting of phase change material by natural convection

Study on the Thermal Energy Storage Phase Change Composite Material with Porous Skeleton

A monolithic model of solid–liquid phase change problem

A General Model for Analyzing the Thermal Performance of the Heat Charging and Discharging Processes of Latent Heat Thermal Energy Storage Systems

Pore scale simulation for melting of composite phase change materials considering interfacial thermal resistance

Experimental and numerical investigation of the melting process and heat transfer characteristics of multiple phase change materials

Analytical modeling of phase change in a composite wall comprising two distinct phase change materials in series

Investigation on the Melting Performance of a Phase Change Material Based on a Shell-and-Tube Thermal Energy Storage Unit with a Rectangular Fin Configuration

Numerical modelling of phase change material melting process embedded in porous media: Effect of heat storage size

Numerical study of heat transfer characteristics of phase change materials reinforced with porous media based on hybrid mesh

A Micromechanical Model for Phase-Change Composites

A novel numerical study on the melting process of phase change materials in a heat exchanger for energy storage

A solid–liquid model based on lattice Boltzmann method for phase change material melting with porous media in cylindrical heat exchangers

Numerical investigations of melting process with sidewall heating under various control parameters

Simulation and Experimental Investigation of the Effect of Pore Shape on Heat Transfer Behavior of Phase Change Materials in Porous Metal Structures