Abstract:The ±1100 kV UHVDC wall bushing is the important power equipment in the ±1100 kV DC power transmission project of China. However, the reported literatures rarely mention its design method and the optimization of its insulation structure. In this paper, two specific designing schemes including the resin impregnated paper (RIP) condenser and the metal-shielded core have been both adopted in the design of the wall bushing. Moreover, the actual operating environment and the rated parameters of the ±1100 kV UHVDC wall bushing have been analyzed in detail. Then, the nonlinear finite element method (FEM) analysis has been applied in the three-dimensional electric stress simulation of the UHVDC wall bushing. The electric field and temperature dependencies of the composite insulation used in the wall bushing have been taken into account. The E-field simulation results indicate that with the RIP condenser, the potential and electric field distribution can be much more uniform along the composite insulator of the bushing. Therefore, the compact design of the wall bushing can be obtained by this designing scheme. On the other hand, with the type of the metal-shielded core, the high E-field strength areas are mainly concentrated on the metal shield and the outer grading ring of the wall bushing. Therefore, the nonlinear FEM was applied in the structure optimization of the internal metal-shielded system used in the wall bushing. Finally, the maximum E-field strength of the wall bushing can meet the control requirement. Based on the simulation results and the optimization structure, the ±660 kV scaled prototype of the UHVDC wall bushing has been produced and passed through all the type tests according to the IEC 62199. The feasibility of the design of the ±1100 kV UHVDC wall bushing has been verified. This paper can provide the theoretical guidelines for the design, manufacture and operation of the UHVDC wall bushing.

Design of the Internal Fuse Dimension for HV Shunt Capacitor in UHV Transmission Projects

Research on Lower Limit of Compensation Degree for UHVA-C Transmission Lines

Study and Design of Main Circuit Parameters for ±800 kV/7 500 MW DC Power Transmission Project From Xiluodu to Zhexi

Study and design of main circuit parameters for ±800 kv/7500 MW DC power transmission project from Xiluodu to Zhexi

Dc Capacitor Parameter Design Of Unified Power Flow Controller With Fault Current Limiting

Optimized Design Method of Permanent Magnets Saturated Core Fault Current Limiters for HVDC Applications

High Voltage Calculations for a 380 kV Superconducting Fault Current Limiter

Comparison of Insulation Coordination Between ±800kv and ±1100kv UHVDC Systems

Insulation structure design and electric field simulation of 500 kV isolation energy supply transformer for HVDC breaker

Design And Test Of Unified Power Flow Controller Protection Circuits

A Calculation Method Of Analytical Dc Fault Current In Mmc-Hvdc Grid Including Current-Limiting Devices

Study on Influences of Shunt Reactor to Internal Overvoltage in UHVAC System

Study on overvoltage and insulation coordination of DC filter for ±800 kV UHVDC project from Xiangjiaba to Shanghai

Research on working condition of key components for fixed series compensation in 1000 kV UHVAC power transmission project

The Simulation Analysis of Electromagnetic Repulsion Mechanism for High-voltage Current-Limiting Fuse

Design and dielectric characteristics of the ??1100 kV UHVDC wall bushing in china

Numerical and Experimental Study of Thermal Behavior of an Electric Fuse in Electric Vehicle Li-Ion Battery Packs

±10 kV DC Vacuum Switch-Fuse Composite Apparatus for Distribution Grid

Analysis and Design in Extra High Voltage Circuit Breakers Employing Shunted Capacitors

Dielectric Characteristics of the ±1100kV UHVDC Wall Bushing with SF6 Gas Insulation

Research on Corona Characteristics and Type Selection of Fittings in Extra High Voltage Alternating Current Substation