Abstract:The series resonance type fault current limiter has the advantages of simple operating principle and topological structure,etc. The primary parameter of series resonance type fault current limiter for high-voltage system is reasonable.However,in the process of restraining fault current after a fault occurrence in electrical network,the capacitor and parallel inverter switch will confront poor working condition.This paper studies the above condition by simulation using the software Matlab.Proceeding from the study,we arrive at the conclusions:1)in the process of closing the inverter switch short circuit capacitor to make the current limiter work in short circuit current limiting mode switching from normal operation mode,there is higher-order of voltage(current)oscillation between capacitor and parallel inverter switch,and the peak value of voltage(current)increases and oscillates with the growing of the speed for closing the inverter switch; 2)when the inverter switch is composed of semiconductor device,control system must respond to short circuit and close the inverter switch quickly,otherwise,the semiconductor device may be damaged by over current(voltage);3)during fault current limiter working in current limiting mode to short circuit loop being shut off by relay protection device,the inverter switch will bear the full fault current and oscillation current.If using semiconductor device as inverter switch,the capacity of semiconductor device must be chosen according to the working condition.

Research on Power Capacitor Internal Fault Criterion

A Diagnostic Criterion for Power Capacitor in Distribution Network

The Numerical Simulation Method of Transformer Internal Short-Circuit Fault

Dc Capacitor Parameter Design Of Unified Power Flow Controller With Fault Current Limiting

Parameter design and optimization of unified power flow controller with fault current limiting

Design and Research of a Novel Unified Power Flow Controller with Fault Current Limiter

FE-based equivalent circuits for simulating transformer internal faults

Research on Comprehensive Closing Protection for Capacitor Based on Atp/Emtp

Statistical Analysis and Preventive Measures of Capacitor Faults in Foshan Power Supply Bureau

Simulation Research on the Effect of the Paralleled Compensating Capacitor on the Solid State Fault Current Limiter Operation

Studies on the Internal Fault Simulations of Powerformer

Investigation of Internal Fault Modeling of Power Former

Design and Realization of Power Equipment Current-carrying Faults Intelligent Warning System

Simulation Study of Series Resonance Type Fault Current Limiter

Research of fault-current limiter for three-phase four-wire power system

Characteristic Analysis and Simulation of Power Capacitor Breakdown in Shunt Capacitor Bank

Study of Insulation Protection for Reactive Compensation Capacitors

AN INDUCTANCE CALCULATION MODEL OF POWER TRANSFORMER FOR INTERNAL FAULT ANALYSIS

Permanent Fault Identification Method Based on Capacitance Parameter

Internal Fault Fast Identification Criterion Based on Superimposed Component Comparison for Power Transformer

An Improved Method for Calculating Fault Component Integrated Impedance to Eliminate the Influence of Phase-to-phase Capacitance Current