Abstract:A novel three-dimensional (3D) hermetic packaging technique suitable for capacitive microelectromechanical systems (MEMS) sensors is studied. The composite substrate with through silicon via (TSV) is used as the encapsulation cap fabricated by a glass-in-silicon (GIS) reflow process. In particular, the low-resistivity silicon pillars embedded in the glass cap are designed to serve as the electrical feedthrough and the fixed capacitance plate at the same time to simplify the fabrication process and improve the reliability. The fabrication process and the properties of the encapsulation cap were studied systematically. The resistance of the silicon vertical feedthrough was measured to be as low as 263.5 mΩ, indicating a good electrical interconnection property. Furthermore, the surface root-mean-square (RMS) roughnesses of glass and silicon were measured to be 1.12 nm and 0.814 nm, respectively, which were small enough for the final wafer bonding process. Anodic bonding between the encapsulation cap and the silicon wafer with sensing structures was conducted in a vacuum to complete the hermetic encapsulation. The proposed packaging scheme was successfully applied to a capacitive gyroscope. The quality factor of the packaged gyroscope achieved above 220,000, which was at least one order of magnitude larger than that of the unpackaged. The validity of the proposed packaging scheme could be verified. Furthermore, the packaging failure was less than 1%, which demonstrated the feasibility and reliability of the technique for high-performance MEMS vacuum packaging.

Wafer-Scale Fabricated MEMS-type Ionization Vacuum Sensors Based on Through Glass Via Technology

A MEMS-Type Ionization Vacuum Sensor with a Wide Measurement Range

A MEMS-Type Ionization Vaccum Sensor Based on an On-Chip Thermionic Electron Source

A Sensitivity-Enhanced Vertical-Resonant MEMS Electric Field Sensor Based on TGV Technology

A Miniature Ionization Vacuum Sensor With a SiO<sub>x</sub>-Based Tunneling Electron Source

Research on Wafer-Level MEMS Packaging with Through-Glass Vias

A Miniaturized Ionization Vacuum Sensor Based on Thermionic Electron Emission From Carbon Nanotubes

Fabrication and wafer-level vacuum packaging of MEMS resonant pressure sensor

Design and Fabrication of High Performance Wafer-Level Vacuum Packaging Based on Glass–silicon–glass Bonding Techniques

A MEMS-Type Hot-cathode Ionization Gauge With Carbon Nanotube-based Electron Emitters

Wafer Level Vacuum Packaging of MEMS-Based Uncooled Infrared Sensors

Implementation of Various Vacuum Conditions in Sealed Chambers for Wafer-Level Bonding by Using Embedded Cavity

A Lateral Differential Resonant Pressure Microsensor Based on SOI-Glass Wafer-Level Vacuum Packaging

Novel Method of Fabricating Fabry-Perot Cavity Employing MEMS Wet-Etching Process

Research on a 3D Encapsulation Technique for Capacitive MEMS Sensors Based on Through Silicon Via

Design and Fabrication of MEMS Acceleration Sensor for Device-Level Vacuum Packaging

Fabrication of SiC MEMS Pressure Sensor Based on Novel Vacuum-Sealed Method

Fabrication and Characterization of a MEMS Thermal Convective Accelerometer on Silicon-in-Glass Substrate

A MEMS Thermopile Pirani Sensor Integrated With Composite Nanoforests for Vacuum Monitoring in Semiconductor Equipment

Vacuum Based Gas Sensing Material Characterization System for Precise and Simultaneous Measurement of Optical and Electrical Responses

A MEMS Friction Gauge For High Vacuum Measurement