Abstract:To enhance the activity of catalysts for CO removal, the perovskite-type catalysts La1-xSrxCoO3 (x = 0, 0.2, 0.4, 0.6, and 0.8) with different Sr2+ doping amount were synthesized by flame spray synthesis (FSS) method. The perovskite-type catalyst synthesized by FSS has a much larger specific surface area (SSA) than that prepared by other conventional methods. The SSA of catalyst increases with the increase of Sr2+ doping amount and the SSA of La0.2Sr0.8CoO3 reaches 31.65 m(2)/g. Compared with other conventional methods, FSS method significantly improves the activity of catalyst and makes it close to the perfor-mances of catalysts with surface modification. The substitution of La3+ by Sr2+ promotes the generation of secondary phase Co3O4 and SrCO3. The catalytic activity of La1-xSrxCoO3 increases with the addition of Sr2+, which results from the increasing active sites and oxygen vacancies. Interestingly, La0.4Sr0.6CoO3 performs the highest activity for CO oxidation and the CO conversion reaches 50% at 148.6 degrees C and 90% at 165.9 degrees C. The oxidation of CO over La1-xSrxCoO3 catalyst may follow a combination of MvK and L-H mechanisms according to the experimental results of H-2-TPR. Moreover, the catalyst exhibits good catalytic activity in consecutive oxidation cycles. In consecutive oxidation experiments with La0.4Sr0.6CoO3, the CO conversion reaches 50% at 168.8 degrees C and 90% at 197.8 degrees C in the eighth oxidation cycle. These results prove that FSS method can further improve the activity of catalysts and is suitable for the preparation of efficient catalysts. (C) 2020 Energy Institute. Published by Elsevier Ltd. All rights reserved.

Chain Effect of Mn4+/ Mn3+ and OLattice on La1-xSrxMnO3 Catalysts for Lower Thermally Driven CO Oxidation

Facile One-Step Flame Synthesis of La1−xSrxMnO3 Nanoparticles for CO Catalytic Oxidation

Effect of Cu Doping on the Structure and Catalytic Activity of LaMnO_3 Catalyst

Effect of Jahn−Teller Distortion in La0.5Sr0.5MnO3 Cubes and Nanoparticles on the Catalytic Oxidation of CO and CH4

Influence of Partial Mn-substitution on Surface Oxygen Species of LaCoO3 Catalysts

Catalytic Behavior of Hydrothermally Synthesized La0.5Sr0.5MnO3 Single-Crystal Cubes in the Oxidation of CO and CH4

Experimental and theoretical studies on the reactivity and reaction mechanism of LaMnO 3 with CO in chemical looping combustion

B-Site modification of LaMn<sub>0.9</sub>Co<sub>0.1</sub>O<sub>3</sub>perovskite using a selective dissolution method in C<sub>3</sub>H<sub>6</sub>oxidation

Role of surface species in CO oxidation over CuO@LaMnO 3 nanocomposites: Effect of calcination temperature

Correlation of Composition, Crystal Structure, Reducibility and Catalytic Oxidation Activity on La-Mn-Ni-O System

Revealing the intrinsic nature of Cu- and Ce-doped Mn3O4 catalysts with positive and negative effects on CO oxidation using operando DRIFTS-MS

Structure, Reduction and Catalytic Properties of Perovskite-Like LaMn1−xNixO3 Oxides

Preparation Of Aromatic Aldehydes From Lignin Oxidation With A Perovskite-Type Catalyst

Investigation of LaMnO3 Catalyst Loaded on HZSM‐5 Zeolite for CO Catalytic Oxidation

Bifunctional CO Oxidation over Mn-mullite Anchored Pt Sub-Nanoclusters Via Atomic Layer Deposition.

The interplay between the suprafacial and intrafacial mechanisms for complete methane oxidation on substituted LaCoO3 perovskite oxides

Investigation of Flame Spray Synthesized La1-xSrxCoO3 Perovskites with Promotional Catalytic Performances on CO Oxidation

Enhanced Catalytic Performance of La-Doped CoMn 2 O 4 Catalysts by Regulating Oxygen Species Activity for VOCs Oxidation

Effects of partial substitution of Cu by Mn and Co in LaCu0.5Ni0.5O3 catalyst synthesized by mechanochemical method in the total oxidation of methane

Synthesis of La1-xSrxCoO3-δ and its catalytic oxidation of NO and its reaction path

Doped Mn modulates the local charge distribution of cobalt-based spinel catalysts to promote the availability of ligand lattice oxygen for complete oxidation of methane