Abstract:There are large amounts of CO pollutants in the off-gas of the iron and steel industry, which cause serious harm to the environment and human health. To control the emission of CO more effectively, in this paper, LaMn1-xCuxO3 (x = 0, 0.25) perovskite catalysts were prepared and then modified by dilute nitric acid. And the physicochemical properties and the catalytic activity of perovskite were investigated and analyzed. The activity results indicate that the Cu2+ substitution and acid treatment could obviously promote the catalytic activity of catalysts for CO oxidation. Among the prepared samples, LaMn0.75Cu0.25O3-H exhibits the highest activity with 90% CO conversion at 176.5 degrees C, and the self-sustained combustion of CO is successfully achieved. And the long-time stability test shows that LaMn0.75Cu0.25O3-H can keep 100% CO conversion, and the activity remains almost unchanged. Combined with the x-ray photoelectron spectroscopy (XPS) and H-2 temperature-programmed reduction (H-2-TPR) results, the increased activity of LaMn0.75Cu0.25O3-H catalyst is mainly ascribed to the high concentration of Mn4+ and abundant oxygen vacancies. On the other hand, the morphology of perovskite catalysts was remolded by acid etching, and the formation of the porous structure significantly increases the specific surface area. The above results show that the substitution of Cu and acid treatment for perovskite catalysts is a feasible strategy to improve CO catalytic combustion activity.

Catalytic Behavior of Hydrothermally Synthesized La0.5Sr0.5MnO3 Single-Crystal Cubes in the Oxidation of CO and CH4

Effect of Jahn−Teller Distortion in La0.5Sr0.5MnO3 Cubes and Nanoparticles on the Catalytic Oxidation of CO and CH4

The High Activity and Stability of La0.5ba0.5mno3 Nanocubes in the Oxidation of Co and Ch4

Effect of Cu Doping on the Structure and Catalytic Activity of LaMnO_3 Catalyst

Effects of partial substitution of Cu by Mn and Co in LaCu0.5Ni0.5O3 catalyst synthesized by mechanochemical method in the total oxidation of methane

Properties of La0.9Sr0.1MnO3 and tourmaline compound catalytic materials for methane combustion

Facile One-Step Flame Synthesis of La1−xSrxMnO3 Nanoparticles for CO Catalytic Oxidation

Correlation Cataluminescence (ctl) Property with Reactivity of Hydrothermally Synthesized La0.8sr0.2mno3 Cubes and Ctl As A Rapid Mode of Screening Catalyst

Study on the Structure and Methane Combustion Activity of Hexaaluminates Catalysts La_(1-x)Sr_xMnAl_(11)O_(19-δ)

Structural Insight into La0.5Ca0.5Mn0.5Co0.5O3 Decomposition in the Methane Combustion Process

Catalytic combustion of methane over various perovskite-type oxides

ICOPE-15-C068 the Selective Catalytic Reduction of NO_x with CH_4 on La_<1-x>Sr_xMnO_3 (x=0.2, 0.4) Catalysts

Synthesis and characterization of Mn3O4 and Mn2O3 nanocrystals on SBA-15: Novel combustion catalysts at low reaction temperatures

Surface structure effects in nanocrystal MnO2 and Ag/MnO2 catalytic oxidation of CO

Correlation of Composition, Crystal Structure, Reducibility and Catalytic Oxidation Activity on La-Mn-Ni-O System

Effect of MnO2 Morphology on Its Catalytic Performance in Lean Methane Combustion

Investigation on the Catalytic Combustion of CO over LaMn 1‐ X Cu X O 3 Promoted by Acid Treatment

Optimizing Citrate Combustion Synthesis of A-Site-Deficient La,Mn-Based Perovskites: Application for Catalytic CH4 Combustion in Stoichiometric Conditions

Surface Modification of Cobalt‐Manganese Mixed Oxide and Its Application for Low‐Temperature Propane Catalytic Combustion

CO Hydrogenation over Nanometer Spinel-Type Co/Mn Complex Oxides Prepared by Sol-Gel Method

Synthesis Of Nanostructure Lamno3 And Lacoo3 Catalysts And Their Catalytic Activity In Oxidation Reaction