Abstract:The thrust of this work is to follow the defect chemistry of the simple LaCoO3 system in an attempt to probe if there is a relationship between the defect chemistry and the activity of this perovskite-type material to catalytic methane combustion. A simple flow-through reactor has been used to study the combustion of methane between room temperature and 1100°C. Using a gel-type precipitation method it has been proved possible to synthesise a single phase perovskite material with a bulk La:Co metal atom ratio of 1:1.1. PXRD, Rietveld analysis and density measurements show that the perovskite phase is non-stoichiometric with a deficiency of lanthanum ions in the lattice. This material is rather ineffective as a catalytic material. A more active form can be prepared at a La:Co metal atom ratio of 1:1 when a mixed phase (perovskite/lanthana) is produced. This material exhibits both higher activity to methane combustion and the storage/evolution of oxygen (as measured using DSC and TPD techniques).The results of activity tests have been rationalised using XPS where large amounts of O− species are seen at the surface. It is proposed that these ions occupy anion vacancies created to compensate for the reduced cation charge in the lattice. This is not possible for the single phase material where vacancies are compensated for by the presence of valency changes of cobalt and/or oxygen.Further work has been carried by doping of the perovskite with cations of valencies +2, +3 and +4 in an attempt to control the non-stoichiometry. In this way, it has been proved possible to provide simple synthetic routes to active methane combustion catalysts.

Structural Insight into La0.5Ca0.5Mn0.5Co0.5O3 Decomposition in the Methane Combustion Process

Effects of partial substitution of Cu by Mn and Co in LaCu0.5Ni0.5O3 catalyst synthesized by mechanochemical method in the total oxidation of methane

Catalytic Behavior of Hydrothermally Synthesized La0.5Sr0.5MnO3 Single-Crystal Cubes in the Oxidation of CO and CH4

Catalytic oxidation over lanthanum-transition metal perovskite materials

Structural investigation of LaCoO3 and LaCoCuO3 perovskite-type oxides and the effect of Cu on coke deposition in the partial oxidation of methane

Deactivation Mechanism of CeO2-Based Mixed Oxide Catalysts Supported on SiO2

Catalytic combustion of methane over various perovskite-type oxides

Catalytic Combustion of Low Concentration Methane over Catalysts Prepared from Co/Mg-Mn Layered Double Hydroxides

Surface Decomposition of Doped PrBaMn 2 O 5+δ Induced by In Situ Nanoparticle Exsolution: Quantitative Characterization and Catalytic Effect in Methane Dry Reforming Reaction

How CO2 poisons La2O3 in an OCM catalytic reaction: A study by in situ XRD-MS and DFT

Pseudo core-shell LaCoO3@MgO perovskite oxides for high performance methane catalytic oxidation

Properties of La0.9Sr0.1MnO3 and tourmaline compound catalytic materials for methane combustion

Insights into key parameters of MnO2 catalyst toward high catalytic combustion performance

Catalytic Performance of Manganese Cobalt Oxides on Methane Combustion at Low Temperature

Enhanced activity and stability of La-doped CeO2 monolithic catalysts for lean-oxygen methane combustion

Investigation of perovskite BaCe1-xMnxO3-δ for methane combustion

Surface in Situ Co-Mn Modification over LaMnO3 Perovskite with Enhanced Activity for Ethane Combustion

Nanocasted Synthesis of the Mesostructured LaCoO3 Perovskite and Its Catalytic Activity in Methane Combustion.

Catalytic performance of La–Ce–O mixed oxide for combustion of methane

Activation of Methane over Perovskite Catalysts

An In Situ Temperature-Dependent Study of La2O3 Reactivation Process