Abstract:Due to the large amounts of CO pollutant from iron ore sintering and vehicle emissions, the control of CO emission becomes more and more important for the environment. To control the emission of CO more effectively, the catalysts of LaMnO3 perovskite with HZSM-5 zeolite as support were prepared by sol-gel method. The structure and catalytic activities of catalysts were characterized and analyzed. According to the results of X-ray diffraction (XRD) and energy-dispersive X-ray spectroscopy (EDS), the LaMnO3 perovskite phase is successfully obtained in all the supported catalysts. The average particle sizes of supported catalysts are in the range of 15-38 mu m. Compared with the perovskite catalysts loaded on other kinds of supports, LaMnO3 supported with HZSM-5 has a larger specific surface area (SSA). The SSAs of supported catalysts with different loading amount are in the range of 190-300 m(2)/g. The HZSM-5 support improves the catalytic activity of LaMnO3 catalyst by increasing the SSA. The activity of supported catalyst becomes higher when the loading amount increases from 20% to 60%. The catalyst with 60% perovskite loaded shows the best activity in CO catalytic oxidation. The CO conversion of 60LM/HZSM-5 attains 50% and 90% at 172.7 degrees C and 201.5 degrees C, respectively. The activities of catalysts with 80% and 100% perovskite loaded decrease due to the accumulated pores formed by too much perovskite. The supported catalysts exhibit favorable activities in consecutive reaction cycles. It turns out that HZSM-5 support is appropriate for the synthesis of active perovskite catalysts for CO oxidation.

Effect of Cu Doping on the Structure and Catalytic Activity of LaMnO_3 Catalyst

Effects of partial substitution of Cu by Mn and Co in LaCu0.5Ni0.5O3 catalyst synthesized by mechanochemical method in the total oxidation of methane

Catalytic Behavior of Hydrothermally Synthesized La0.5Sr0.5MnO3 Single-Crystal Cubes in the Oxidation of CO and CH4

Influence of Partial Mn-substitution on Surface Oxygen Species of LaCoO3 Catalysts

Effect of Jahn−Teller Distortion in La0.5Sr0.5MnO3 Cubes and Nanoparticles on the Catalytic Oxidation of CO and CH4

Investigation on the Catalytic Combustion of CO over LaMn 1‐ X Cu X O 3 Promoted by Acid Treatment

Structure, Reduction and Catalytic Properties of Perovskite-Like LaMn1−xNixO3 Oxides

Preparation Of Aromatic Aldehydes From Lignin Oxidation With A Perovskite-Type Catalyst

Improvement of CO Oxidation and CH4 Combustion by Pd and Pt Partial Substitution on LaMn0.5Cu0.5O3 Perovskite

Role of surface species in CO oxidation over CuO@LaMnO 3 nanocomposites: Effect of calcination temperature

The Effect of Cu-doping on the Magnetic and Transport Properties of La0.7Sr0.3MnO3

Correlation of Composition, Crystal Structure, Reducibility and Catalytic Oxidation Activity on La-Mn-Ni-O System

Structural Characterization and Co Oxidation Activity of Nanostructured Lamno3 Catalysts

Preparation and evaluation of the LaCu1-xNixO3 (x = 0, 0.1, 0.3, 0.5 and 0.7) perovskite catalysts for total oxidation of methane

The High Activity and Stability of La0.5ba0.5mno3 Nanocubes in the Oxidation of Co and Ch4

No Oxidation Catalysis on Copper Doped Hexagonal Phase Lacoo3: A Combined Experimental and Theoretical Study

B-Site modification of LaMn<sub>0.9</sub>Co<sub>0.1</sub>O<sub>3</sub>perovskite using a selective dissolution method in C<sub>3</sub>H<sub>6</sub>oxidation

Investigation of LaMnO3 Catalyst Loaded on HZSM‐5 Zeolite for CO Catalytic Oxidation

Structural investigation of LaCoO3 and LaCoCuO3 perovskite-type oxides and the effect of Cu on coke deposition in the partial oxidation of methane

Effect of polymerization/complexation agents molar ratio on structure and catalytic activity of La0.7Ba0.3Co0.3Ni0.7O3 nanocatalyst in low-temperature CO oxidation

The effect of Cu-doping on the magnetic and transport properties of La 0