Abstract:Due to the large amounts of CO pollutant from iron ore sintering and vehicle emissions, the control of CO emission becomes more and more important for the environment. To control the emission of CO more effectively, the catalysts of LaMnO3 perovskite with HZSM-5 zeolite as support were prepared by sol-gel method. The structure and catalytic activities of catalysts were characterized and analyzed. According to the results of X-ray diffraction (XRD) and energy-dispersive X-ray spectroscopy (EDS), the LaMnO3 perovskite phase is successfully obtained in all the supported catalysts. The average particle sizes of supported catalysts are in the range of 15-38 mu m. Compared with the perovskite catalysts loaded on other kinds of supports, LaMnO3 supported with HZSM-5 has a larger specific surface area (SSA). The SSAs of supported catalysts with different loading amount are in the range of 190-300 m(2)/g. The HZSM-5 support improves the catalytic activity of LaMnO3 catalyst by increasing the SSA. The activity of supported catalyst becomes higher when the loading amount increases from 20% to 60%. The catalyst with 60% perovskite loaded shows the best activity in CO catalytic oxidation. The CO conversion of 60LM/HZSM-5 attains 50% and 90% at 172.7 degrees C and 201.5 degrees C, respectively. The activities of catalysts with 80% and 100% perovskite loaded decrease due to the accumulated pores formed by too much perovskite. The supported catalysts exhibit favorable activities in consecutive reaction cycles. It turns out that HZSM-5 support is appropriate for the synthesis of active perovskite catalysts for CO oxidation.

B-Site modification of LaMn<sub>0.9</sub>Co<sub>0.1</sub>O<sub>3</sub>perovskite using a selective dissolution method in C<sub>3</sub>H<sub>6</sub>oxidation

Influence of Partial Mn-substitution on Surface Oxygen Species of LaCoO3 Catalysts

Synthesis of higher alcohols by CO hydrogenation over catalysts derived from LaCo1-xMnxO3 perovskites: Effect of the partial substitution of Co by Mn

A-site cations tailoring the activity of LnMnO 3 perovskites for CO and propane oxidation

Structural modification of LaCoO 3 perovskite for oxidation reactions: The synergistic effect of Ca 2+ and Mg 2+ co-substitution on phase formation and catalytic performance

Improvement of CO Oxidation and CH4 Combustion by Pd and Pt Partial Substitution on LaMn0.5Cu0.5O3 Perovskite

Selective Dissolution of A‐Site Cations in ABO3 Perovskites: A New Path to High‐Performance Catalysts

Investigation of LaMnO3 Catalyst Loaded on HZSM‐5 Zeolite for CO Catalytic Oxidation

Engineering Active Surface Oxygen Sites of Cubic Perovskite Cobalt Oxides Toward Catalytic Oxidation Reactions

Cobalt-Doped Perovskite-Type Oxide LaMnO3 as Bifunctional Oxygen Catalysts for Hybrid Lithium-Oxygen Batteries

Transforming Plain LaMnO 3 Perovskite into a Powerful Ozonation Catalyst: Elucidating the Mechanisms of Simultaneous A and B Sites Modulation for Enhanced Toluene Degradation

Investigation on the Catalytic Combustion of CO over LaMn 1‐ X Cu X O 3 Promoted by Acid Treatment

Sr‐doped Double Perovskite La2CoMnO6 to Promote the Oxygen Evolution Reaction Activity

Effect of Cu Doping on the Structure and Catalytic Activity of LaMnO_3 Catalyst

La0.8Sr0.2Mn0.8Co0.2O3-δ perovskite as an efficient functional electrocatalyst for oxygen reduction reactions

Surface Modification of Cobalt‐Manganese Mixed Oxide and Its Application for Low‐Temperature Propane Catalytic Combustion

Enhanced Catalytic Activity for NO Oxidation over Ba Doped LaCoO3 Catalyst

Optimizing Citrate Combustion Synthesis of A-Site-Deficient La,Mn-Based Perovskites: Application for Catalytic CH4 Combustion in Stoichiometric Conditions

Structure, Reduction and Catalytic Properties of Perovskite-Like LaMn1−xNixO3 Oxides

Synthesis Of Nanostructure Lamno3 And Lacoo3 Catalysts And Their Catalytic Activity In Oxidation Reaction

B-site cation synergy in Mn doped LaCoO 3 for enhanced electrocatalysts for electrochemical reduction of nitrate