Abstract:To enhance the activity of catalysts for CO removal, the perovskite-type catalysts La1-xSrxCoO3 (x = 0, 0.2, 0.4, 0.6, and 0.8) with different Sr2+ doping amount were synthesized by flame spray synthesis (FSS) method. The perovskite-type catalyst synthesized by FSS has a much larger specific surface area (SSA) than that prepared by other conventional methods. The SSA of catalyst increases with the increase of Sr2+ doping amount and the SSA of La0.2Sr0.8CoO3 reaches 31.65 m(2)/g. Compared with other conventional methods, FSS method significantly improves the activity of catalyst and makes it close to the perfor-mances of catalysts with surface modification. The substitution of La3+ by Sr2+ promotes the generation of secondary phase Co3O4 and SrCO3. The catalytic activity of La1-xSrxCoO3 increases with the addition of Sr2+, which results from the increasing active sites and oxygen vacancies. Interestingly, La0.4Sr0.6CoO3 performs the highest activity for CO oxidation and the CO conversion reaches 50% at 148.6 degrees C and 90% at 165.9 degrees C. The oxidation of CO over La1-xSrxCoO3 catalyst may follow a combination of MvK and L-H mechanisms according to the experimental results of H-2-TPR. Moreover, the catalyst exhibits good catalytic activity in consecutive oxidation cycles. In consecutive oxidation experiments with La0.4Sr0.6CoO3, the CO conversion reaches 50% at 168.8 degrees C and 90% at 197.8 degrees C in the eighth oxidation cycle. These results prove that FSS method can further improve the activity of catalysts and is suitable for the preparation of efficient catalysts. (C) 2020 Energy Institute. Published by Elsevier Ltd. All rights reserved.

Enhanced Catalytic Activity for NO Oxidation over Ba Doped LaCoO3 Catalyst

Synthesis of La1-xSrxCoO3-δ and its catalytic oxidation of NO and its reaction path

Catalytic Activity of La1-Xsrxcoo3 (X=0.2-0.8) Supported on Porous Mullite Fiber Ceramics for No and Co

Effect of polymerization/complexation agents molar ratio on structure and catalytic activity of La0.7Ba0.3Co0.3Ni0.7O3 nanocatalyst in low-temperature CO oxidation

Catalytic Reduction of NO by CO over B-site Partially Substituted LaM0.25Co0.75O3 (M = Cu, Mn, Fe) Perovskite Oxide Catalysts: the Correlation Between Physicochemical Properties and Catalytic Performance

Influence of Partial Mn-substitution on Surface Oxygen Species of LaCoO3 Catalysts

NO Reduction by CO over Highly Active and Stable Perovskite Oxide Catalysts La0.8Ce0.2M0.25Co0.75O3 (M = Cu, Mn, Fe): Effect of the Role in B Site

Structure, Reduction and Catalytic Properties of Perovskite-Like LaMn1−xNixO3 Oxides

Impact of dopants on the sulfation, desulfation and NOx reduction performance of Ba-based NOx storage-reduction catalysts

B-Site modification of LaMn<sub>0.9</sub>Co<sub>0.1</sub>O<sub>3</sub>perovskite using a selective dissolution method in C<sub>3</sub>H<sub>6</sub>oxidation

Mesoporous LaCoO3 perovskite oxide with high catalytic performance for NO storage and reduction

Effect of Cu Doping on the Structure and Catalytic Activity of LaMnO_3 Catalyst

No Oxidation Catalysis on Copper Doped Hexagonal Phase Lacoo3: A Combined Experimental and Theoretical Study

Synthesis of Nd_(2-x)Sr_xCoO_(4±λ)(x=0.4～1.2) and Catalytic Properties in Reduction of NO

Investigation of Flame Spray Synthesized La1-xSrxCoO3 Perovskites with Promotional Catalytic Performances on CO Oxidation

Promotion effects of LaCoO 3 formation on the catalytic performance of Co–La oxides for soot combustion in air

ACTIVITY AND SO2-POISONING RESISTANCE OF La_(0.8)M_(0.2)CoO_3(M=Sr,Ce,Ba,Ca) PEROVSKITE CATALYSTS FOR VOCS CATALYTIC COMBUSTION

Promotional Role of La Addition in the NO Oxidation Performance of a SmMn2O5 Mullite Catalyst

Synthesis Of Nanostructure Lamno3 And Lacoo3 Catalysts And Their Catalytic Activity In Oxidation Reaction

Tuning the A‐site Element in LaCo0.8Fe0.2O3 Perovskite‐based Catalyst for High Temperature N2O Decomposition in Nitric Acid Plant

Comparative study of La1–Ce MnO3+ perovskites and Mn–Ce mixed oxides for NO catalytic oxidation