Abstract:High heat flux test facilities throughout the world performed transient heat loads testing to assess the efficiency and fatigue life of a variety of plasma-facing materials and design concepts. However, the penetration depth of the energetic particles is known to have a strong influence on the results of transient heating tests since the temperature is not in equilibrium when failures or significant events occur. Therefore we have developed a numerical approach to quantitatively investigate the thermal behavior in transient heat loads testing of plasma-facing materials. The approach is mainly based on the Monte Carlo method to simulate the trajectories of particles and the classical heat transfer model to calculate the temperature distribution inside a solid, which allows us to calculate the energy deposition distributions and the fraction of incident electron energy deposited (or the ratios of absorbed power density vs. the incident power density) in thermal materials for fusion reactor applications. In particular, the temperature distributions of plasma-facing materials of Be and W under different conditions (acceleration voltage, absorbed power density, duration time and category of material) are studied within this framework. The volumetric heating effect to the surface temperature of materials is much stronger for the low-Z materials like Be than for the high-Z materials like W, where the deviation of surface temperatures between different acceleration voltages can be up to 20% for low-Z materials. The framework of numerically simulating the mechanics for high heat flux testing of plasma-facing materials has been coded as the IRadMat package. (C) 2011 Elsevier B.V. All rights reserved.

PERFORM: High Temperature and Pressure CHF Experiment Bench under Six Degrees of Freedom Motion Condition

Progress of High Heat Flux Component Manufacture and Heat Load Experiments in China

Experimental Study of Boiling Critical Heat Flux with Low Mass Flux under Motion Condition in a Wetted Perimeter Equivalent Rod

Investigation on the Critical Heat Flux in Typical 5 by 5 Rod Bundle at Conditions Prototypical of PWR Based on CFD Methodology

A Blowdown Critical Heat Flux Experimental Vehicle

Investigation on the Critical Heat Flux in a 2 by 2 Fuel Assembly under Low Flow Rate and High Pressure with a CFD Methodology

Numerical Investigation on Boiling Crisis in a Full-Length 5 × 5 Fuel Assembly under Typical Pressurized Water Reactor Conditions

Dynamic Simulation of Warm Compressor Station for SHINE Test Facility Cryoplant

Fluid-to-fluid Modeling of Critical Heat Flux in 4×4 Rod Bundles

Study on the Prediction of DNB-Type Critical Heat Flux in Rod Bundle Under Motion Conditions

An experimental study of the CHF in a square channel with non-uniformly heated rod under low pressure and low flow conditions

OpenFOAM CFD simulation of critical heat flux in vertical pipe under typically PWR conditions

Program Development and Preliminary CHF Characteristics Analysis for Natural Circulation Loop under Moving Condition

Experimental Investigation On Critical Heat Flux From Downward Facing Flat Plate For Different Orientation Angles

Numerical investigation on critical heat flux for 5 × 5 fuel assemblies with a wide range of working conditions

Experimental and Mechanical Research on Chf Characteristics During Combined/Bottom Quenching in Narrow Rectangular Channel

Researches in the Flow Modeling of Critical Heat Flux in Bundle

Experimental Investigation of the Heaving Motion Effect on Critical Heat Flux Phenomena and Wall Temperature Fluctuation Using R134a for Floating Nuclear Applications

Theoretical Simulation of Thermal Behavior in Transient Heat Loads Testing of Plasma-Facing Materials

Experimental Study on Critical Heat Flux in Bilaterally Heated Narrow Annuli

Experimental study of the key factors of improving CHF to support CAP1400 IVR strategy