Abstract:In vessel retention (IVR) is one of the key severe accident mitigation strategies to maintain reactor pressure vessel (RPV) integrity. IVR designs utilize the reactor pressure vessel lower head to contain molten fuel and rely on external reactor vessel cooling (ERVC) to remove decay heat. The capacity of ERVC is limited by the critical heat flux (CHF) of flow boiling on the outside of the reactor vessel surface. Therefore, the determination of critical heat flux (CHF) is crucial to predict whether the adoption of IVR would be successful in mitigating severe accidents. In 1999, Celeta et.al proposed a superheated layer vapor replenishment model. In this model they postulated that CHF would occur when the superheated layer was occupied by the vapor blanket coming into contact with the heated wall and they successfully predicted the critical heat flux in subcooled water flow boiling under high mass flux, high liquid subcooling and low/medium pressure conditions. To evaluate the practicability of this model in predicting CHF under IVR conditions, CHF experiments were performed under natural circulation conditions on the experiment facility "Test of External Vessel Surface with Enhanced Cooling" (TESEC). Experiments are conducted in a 30 mm wide, 61mm high rectangular flow channel with a 200 mm long heated surface along the flow direction. Two quartz windows are installed at the sidewalls of the flow channel for visualization. In order to simulate various positions of the reactor lower head, experiments at different inclination angles of the test section were conducted. The high speed visualization data at CHF point at various inclination angles were processed and analyzed by a MATLAB code developed by the author. The vapor blanket thickness at various inclination angles was measured from the visualization data and was also predicted by the Celeta model. By using geometry data from high speed images, CHF values were calculated by Celeta model and compared with the experimental results at various inclination angles. Limitations of the Celeta model in adaptation of predicting CHF under IVR conditions were further discussed.

An experimental study of the CHF in a square channel with non-uniformly heated rod under low pressure and low flow conditions

An experimental study on critical heat flux for low flow and low pressure of water in a hexagonal 7-rod bundle channel

Subchannel Analysis of Critical Heat Flux in Radially Non-Uniform Heated Rod Assembly at Low Flow Rate

Experimental investigation and a mechanical model of critical heat flux in a narrow rectangular channel

Boiling heat transfer and CHF for subcooled water flowing in a narrow channel due to power transients

Research on prediction of non-uniform heated rod bundle CHF based on subchannel analysis code coupling modified mechanistic model

Separate factors’ effects on CHF for flow boiling in an inclined rectangular channel under low mass flux

Prediction of Critical Heat Flux in Non-Uniform Heated Rod Bundle Based on Modified CHF Empirical Correlations

COMPARISON ANALYSIS OF CHF PARAMETRIC TRENDS IN VERTICAL TUBE AND 5 x 5 BUNDLE

Experimental Study on the Chf Characteristics with Different Coolant Injection Conditions and Degassing Effects on A Downward-Facing Plane

Prediction of Critical Heat Flux for Subcooled Flow Boiling in Annulus and Transient Surface Temperature Change at CHF

THE EFFECT OF CHANNEL HEIGHT ON FLOW BOILING HEAT TRANSFER AND CHF IN FLAT MINICHANNELS WITH LOCAL HEATING

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Investigation of flow boiling critical heat flux and heat transfer within a horizontally oriented channel with one-sided heating at three levels of subcooled inlet

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Observing Investigation of Boiling Characteristics Around CHF for the Downward Facing Heating Surface

Study on the Prediction of DNB-Type Critical Heat Flux in Rod Bundle Under Motion Conditions

Prediction of “critical heat flux” for supercritical water and CO2 flowing upward in vertical heated tubes

Impact of Conjugate Heat Transfer on the Turbulence and Heat Transfer in an Upward Heated Pipe Flow at Supercritical Pressure

Prediction Of subcooled water flow boiling critical heat flux (CHF) at low pressure

A Critical Heat Flux Model for Saturated Flow Boiling on the Downward Curved Heated Surface