Abstract:In vessel retention (IVR) is one of the key severe accident mitigation strategies to maintain reactor pressure vessel (RPV) integrity. IVR designs utilize the reactor pressure vessel lower head to contain molten fuel and rely on external reactor vessel cooling (ERVC) to remove decay heat. The capacity of ERVC is limited by the critical heat flux (CHF) of flow boiling on the outside of the reactor vessel surface. Therefore, the determination of critical heat flux (CHF) is crucial to predict whether the adoption of IVR would be successful in mitigating severe accidents. In 1999, Celeta et.al proposed a superheated layer vapor replenishment model. In this model they postulated that CHF would occur when the superheated layer was occupied by the vapor blanket coming into contact with the heated wall and they successfully predicted the critical heat flux in subcooled water flow boiling under high mass flux, high liquid subcooling and low/medium pressure conditions. To evaluate the practicability of this model in predicting CHF under IVR conditions, CHF experiments were performed under natural circulation conditions on the experiment facility "Test of External Vessel Surface with Enhanced Cooling" (TESEC). Experiments are conducted in a 30 mm wide, 61mm high rectangular flow channel with a 200 mm long heated surface along the flow direction. Two quartz windows are installed at the sidewalls of the flow channel for visualization. In order to simulate various positions of the reactor lower head, experiments at different inclination angles of the test section were conducted. The high speed visualization data at CHF point at various inclination angles were processed and analyzed by a MATLAB code developed by the author. The vapor blanket thickness at various inclination angles was measured from the visualization data and was also predicted by the Celeta model. By using geometry data from high speed images, CHF values were calculated by Celeta model and compared with the experimental results at various inclination angles. Limitations of the Celeta model in adaptation of predicting CHF under IVR conditions were further discussed.

OpenFOAM CFD simulation of critical heat flux in vertical pipe under typically PWR conditions

Prediction of Critical Heat Flux for Subcooled Flow Boiling in Annulus and Transient Surface Temperature Change at CHF

Numerical study of heat transfer and pressure drop characteristics in helical tubes based on OpenFOAM

Numerical investigation on critical heat flux for 5 × 5 fuel assemblies with a wide range of working conditions

Influence of non-uniform wall heat flux on critical heat flux prediction in upward flowing round pipe two-phase flow

Experimental Investigation of the Heaving Motion Effect on Critical Heat Flux Phenomena and Wall Temperature Fluctuation Using R134a for Floating Nuclear Applications

Experimental investigation and a mechanical model of critical heat flux in a narrow rectangular channel

A Critical Heat Flux Model for Saturated Flow Boiling on the Downward Curved Heated Surface

Subchannel Analysis of Critical Heat Flux in Radially Non-Uniform Heated Rod Assembly at Low Flow Rate

A CHF Correlation and Flow Pattern Observation on a Downward-Facing Boiling Surface

Study on the Prediction of DNB-Type Critical Heat Flux in Rod Bundle Under Motion Conditions

A Blowdown Critical Heat Flux Experimental Vehicle

A Review of CFD Advancements Toward Thermal-Hydraulic Analysis of Prototypical Flow Conditions in PWR Subchannels

CFD simulation on the transient process of coolant mixing phenomenon in reactor pressure vessel

CFD study of two-phase cross flow and heat transfer in sub-channels of pressurized water reactor fuel assemblies

Prediction Of subcooled water flow boiling critical heat flux (CHF) at low pressure

CFD analysis for full vessel upper plenum in Maanshan Nuclear Power Plant

Numerical Investigation of Flow Boiling Characteristics in Narrow Rectangular Channels Using Two-Fluid Eulerian Cfd Model Covering a Wide Range of Pressures

CFD modelling of buoyancy driven flows in enclosures with relevance to nuclear reactor safety

Multiphase CFD-based critical heat flux predictions for single-element heaters at CANDU reactor conditions

Prediction of “critical heat flux” for supercritical water and CO2 flowing upward in vertical heated tubes