Abstract:In recent years, 3D printing has been rapidly promoted and applied in the field of civil engineering and construction, and has been developed from landscape maintenance structures to load-bearing structures. Different from cast-in-place concrete materials, the contact interfaces between adjacent layers or filaments formed under the additive stacking process lead to distinct mechanical anisotropy of 3D printed concrete materials, and thus the mechanical model of traditional concrete materials and the design method of reinforced concrete structures are inapplicable to 3D printed concrete materials and structures. The establishment of 3D printed concrete materials is therefore of great significance to the design of 3D printed concrete structures. Currently, there is still a lack of research on the constitutive models of 3D printed fiber reinforced concrete. This study tested and analyzed the tensile and shear performances of 3D printed concrete reinforced with steel fibers and polypropylene fibers. According to the distribution porosity, the interface thickness of 3D printed fiber reinforced concrete was measured and determined. The constitutive modeling of mechanical anisotropy of 3D printed fiber-reinforced concrete were established based on the theory of damage fracture of concrete and experimental results. Results show that the interfacial tensile strength at layers and filaments of 3D printed concrete with steel fiber were 6.2 MPa and 6.9 MPa, while the capacities of 3D printed concrete with polypropylene fiber were 4.5 MPa and 4.7 MPa, respectively. The fracture damage constitutive model adopted in this study has favorable fitting degrees, which would contribute to the further finite element simulation and structural design of 3D printed concrete.

Flexural Performance of the Integrated Steel Truss Reinforced 3D Printed Concrete Beams: Experimental and Numerical Analysis

Bond shear performances and constitutive model of interfaces between vertical and horizontal filaments of 3D printed concrete

Flexural performance of 3D-printed composite beams with ECC and recycled fine aggregate concrete: Experimental and numerical analysis

Effect of Reinforcement Configurations on the Flexural Behaviors of 3D Printed Fiber Reinforced Cementitious Composite (FRCC) Beams

Experimental and numerical study on the flexural behavior of 3D-printed composite beams with U-shaped ECC formwork

The Influence of Three-Dimensionally Printed Polymer Materials as Trusses and Shell Structures on the Mechanical Properties and Load-Bearing Capacity of Reinforced Concrete

Bending Behaviour of Steel Cable Reinforced 3D Printed Concrete in the Direction Perpendicular to the Interfaces

Experimental study on flexural behavior of partially precast high-strength steel reinforced ultra-high performance concrete beam

Finite Element Analysis of 3D Printed Steel-fiber RC Beam for Mechanical Performance

3D-printing ultra-high performance fiber-reinforced concrete under triaxial confining loads

Bonding performance of 3D printing concrete with self-locking interfaces exposed to compression–shear and compression–splitting stresses

Flexural Behaviors of 3D Printed Lightweight Engineered Cementitious Composites (ECC) Slab with Hollow Sections

Mechanical behaviors of 3D printed lightweight concrete structure with hollow section

Mechanical behavior of FRP sheets reinforced 3D elements printed with cementitious materials

Trans-layer and inter-layer fracture behavior of extrusion-based 3D printed concrete under three-point bending

Design and Optimization of 3D-Printed Variable Cross-Section I-Beams Reinforced with Continuous and Short Fibers

Flexural Behavior of Textile Reinforced 3D Printed Concrete under Quasi-Static and Dynamic Impact Loads

U-type steel wire mesh for the flexural performance enhancement of 3D printed concrete: A novel reinforcing approach

Cyclic behavior of unbonded post-tensioned precast segmental concrete columns fabricated by 3D printed concrete permanent formwork

Interfacial constitutive model of 3D printed fiber reinforced concrete composites and its experimental validation

Mechanical Properties and Failure Mechanism of 3D Printing Ultra-High Performance Concrete