Abstract:In recent years, 3D printing has been rapidly promoted and applied in the field of civil engineering and construction, and has been developed from landscape maintenance structures to load-bearing structures. Different from cast-in-place concrete materials, the contact interfaces between adjacent layers or filaments formed under the additive stacking process lead to distinct mechanical anisotropy of 3D printed concrete materials, and thus the mechanical model of traditional concrete materials and the design method of reinforced concrete structures are inapplicable to 3D printed concrete materials and structures. The establishment of 3D printed concrete materials is therefore of great significance to the design of 3D printed concrete structures. Currently, there is still a lack of research on the constitutive models of 3D printed fiber reinforced concrete. This study tested and analyzed the tensile and shear performances of 3D printed concrete reinforced with steel fibers and polypropylene fibers. According to the distribution porosity, the interface thickness of 3D printed fiber reinforced concrete was measured and determined. The constitutive modeling of mechanical anisotropy of 3D printed fiber-reinforced concrete were established based on the theory of damage fracture of concrete and experimental results. Results show that the interfacial tensile strength at layers and filaments of 3D printed concrete with steel fiber were 6.2 MPa and 6.9 MPa, while the capacities of 3D printed concrete with polypropylene fiber were 4.5 MPa and 4.7 MPa, respectively. The fracture damage constitutive model adopted in this study has favorable fitting degrees, which would contribute to the further finite element simulation and structural design of 3D printed concrete.

Effect of Reinforcement Configurations on the Flexural Behaviors of 3D Printed Fiber Reinforced Cementitious Composite (FRCC) Beams

Investigation on Flexural Performance of RC Beams Flexurally Strengthened by Side-bonded CFRP Laminates

Mechanical behavior of FRP sheets reinforced 3D elements printed with cementitious materials

Flexural performance of 3D-printed composite beams with ECC and recycled fine aggregate concrete: Experimental and numerical analysis

Experimental and numerical study on the flexural behavior of 3D-printed composite beams with U-shaped ECC formwork

Behavior of Preloaded RC Beams Strengthened with CFRP Laminates

Effect of sustaining load level on flexural behavior of RC beams retrofitted with CFRP sheets

Mechanical properties of a 3D-printed SFRC beam with steel fiber distribution adaptive to tensile stress

Investigation On Flexural Behavior Of Reinforced Concrete Beams Flexurally Strengthened By Different Methods

Effect of Shear Resistance on Flexural Debonding Load-Carrying Capacity of RC Beams Strengthened with Externally Bonded FRP Composites

Study on flexural performance of cracked RC beams retrofitted with CFRP sheets

Experimental Investigation on Flexural Capacity of Reinforced Concrete Beams Strengthened with 3D-Fiberglass, CFRP and GFRP

Interfacial constitutive model of 3D printed fiber reinforced concrete composites and its experimental validation

Bending Properties and Failure Behavior of 3D Printed Fiber Reinforced Resin T‐beam

3D FRP Reinforcement Systems for Concrete Beams: Innovation towards High Performance Concrete Structures

Flexural Performance of Concrete Beams Reinforced with Continuous FRP Bars and Discrete Steel Fibers under Cyclic Loads

A Comprehensive Study on the Effect of Reinforcing Methods on the Flexural Behaviour of Concrete-RUHTCC Composite Beams

3D-printing ultra-high performance fiber-reinforced concrete under triaxial confining loads

Flexural Performance of Steel-Continuous-Fiber Composite Bar and Fiber-Reinforced Polymer Bar Hybrid-Reinforced Sustainable Sea-Sand Concrete Beams: Numerical and Theoretical Study

Experimental and theoretical study on flexural behavior of steel-concrete composite beams strengthened by CFRP plates with unbonded retrofit systems

Investigation of bending properties of continuous fiber reinforced resin T-beams made by 3D printing