Abstract:Vertical centrifugal casting can significantly enhance the filling capability of molten metals, enabling the production of complex thin-walled castings at near-rapid cooling rates. In this study, the melt flow, solidification structures, and defects in 316 L steel cast strips with a geometry of 80 mm × 60 mm × 2.5 mm produced by vertical centrifugal casting were numerically and experimentally analyzed under different rotation speeds. With gradually increasing the rotation speed from 150 r/min to 900 r/min, the simulated results showed the shortest filling time and minimum porosity volume in the cast strip at a rotation speed of 600 r/min. Since a strong turbulent flow was generated by the rotation of the mold cavity during the filling process, experimental results showed that a "non-dendritic" structure was obtained in 316 L cast strip when centrifugal force was involved, whereas the typical dendritic structure was observed in the reference sample without rotation. Most areas of the cast strip exhibited one-dimensional cooling, but three-sided cooling appeared near the side of the cast strip. Moreover, the pores and cracks in the 316 L strips were detected by computed tomography scanning and analyzed with the corresponding numerical simulations. Results indicated the existence of an optimal rotational speed for producing cast strips with minimal casting defects. This study provides a better understanding of the filling and solidification processes of strips produced by vertical centrifugal casting.

Solidification Structure of Low Carbon Steel Strips with Different Phosphorus Contents Produced by Strip Casting

Effect of Phosphorus on the Microstructure and Mechanical Properties of Strip Cast Carbon Steel

Inversed Phosphorus Segregation in Twin Roll Cast Strips for Improvement of Mechanical Properties and Weathering Resistance

On the Formation of P-Rich Surface Layer of Twin-Roll Cast High-P Strip

Characterization of the Solidification Structure and Texture Development of Ferritic Stainless Steel Produced by Twin-Roll Strip Casting

Solidification structure and crystallographic texture of strip casting 3 wt.% Si non-oriented silicon steel

Microstructure and mechanical behavior of a low-density Fe–12Mn–9Al–1.2C steel prepared using centrifugal casting under near-rapid solidification

Study on new type weathering-resistance steel strip developed by twin-roll strip casting

The improvement of weathering resistance by increasing P contents in cast strips of low carbon steels

Research status and prospect of direct strip casting manufactured low-carbon microalloyed steel

Effect of Basicity on the Solid Solution Behavior of Phosphorus and In Situ Separation of nC2S–C3P Solid Solution from Molten Steelmaking Slag via Super-Gravity

Fabrication and properties of strip casting 4.5 wt% Si steel thin sheet

Microstructures and Mechanical Properties of Low Carbon Steel Hot Rolled in Ferrite Region Based on CSP Line

Effect of Phosphorus Content on Magnetic and Mechanical Properties of Non-Oriented Electrical Steel

Solidification Structures of Fe–Cr–Ni–Mo–N Super-austenitic Stainless Steel Processed by Twin-roll Strip Casting and Ingot Casting and Their Segregation Evolution Behaviors

Melt flow, solidification structures, and defects in 316 L steel strips produced by vertical centrifugal casting

Texture and Formability of Cr17 Ferritic Stainless Steel by Thin Strip Casting and Conventional Process

Microstructure, texture and magnetic properties of strip-cast 1.3% Si non-oriented electrical steels

Effect of Continuous Casting Technology on Low-Alloy Steel Structure in Different Production Stages

Study on the Effect of Different Factors on the Change of the Phosphorus-Rich Phase in High Phosphorus Steel Slag

Development of Thin Slab Continuous Casting-Direct Rolling Process and Microalloyed High Strength Steel