Abstract:In this study, a new type of duplex stainless steel was successfully developed through innovative composition design and special preparation process. Based on the composition of Fe-19Cr-1Ni-0.6Al-12Mn, the material uses Mn to replace part of Ni and Al to replace part of Cr, thus realizing cost optimization and performance improvement. The special feature is that ferrite phase becomes dominant during hot rolling, which significantly improves the corrosion resistance and mechanical properties of the material. In order to accurately control the austenite phase, cold rolling and annealing techniques were combined in the study. This kind of duplex stainless steel has excellent thermos-plasticity, mechanical properties and corrosion resistance, and the cost advantage is obvious. However, its corrosion resistance, especially σ phase precipitation behavior, still needs to be further studied, which is an important application challenge of duplex stainless steel. The experimental results show that the corrosion resistance of the experimental steel decreases greatly under low-temperature heat treatment, which is attributed to the precipitation of σ phase (chromium-rich) at the grain boundary during annealing at 780 °C, leading to the redistribution of alloy elements and chromium-poor phenomenon. The amount of σ phase precipitation changes with the increase in aging time, but compared with the traditional duplex stainless steel, the newly developed duplex stainless steel precipitates σ phase slowly. The reason behind this is that during the annealing process, the recovery recrystallization of ferrite in the structure is inhibited, which provides more time windows for the precipitation of σ phase. It can be seen that by optimizing the preparation process, we can effectively slow down the precipitation trend of σ phase and lay a foundation for improving the properties and application prospects of duplex stainless steel.

Study on new type weathering-resistance steel strip developed by twin-roll strip casting

Solidification Structure of Low Carbon Steel Strips with Different Phosphorus Contents Produced by Strip Casting

Inversed Phosphorus Segregation in Twin Roll Cast Strips for Improvement of Mechanical Properties and Weathering Resistance

The improvement of weathering resistance by increasing P contents in cast strips of low carbon steels

Theory and Technology of Ultrafine Grained Weathering Steel with P and RE Combined Addition

A Newly Designed High-Strength Tool Steel with High Wear and Corrosion Resistance

The Screening of Reasonable Copper and Phosphorus Content in Weathering Steel by a High-Throughput Experimental Method

Effect of Phosphorus on the Microstructure and Mechanical Properties of Strip Cast Carbon Steel

On the Formation of P-Rich Surface Layer of Twin-Roll Cast High-P Strip

Microstructure and Mechanical Property of Strip in Fe–23Mn–3Si–3Al TWIP Steel by Twin Roll Casting

Mechanism of Improved Ductility of 1500 MPa-class Ultra-high Strength Cold-rolled Steel Sheet Produced by Rolling and Partitioning Method

Experimental Study on the Twin Roll Strip Casting and Warm Rolling Fe-6.5 Wt. %si Steel Sheet

Effects of Rare Earth Elements on Microstructure and Corrosion Resistance of Low Alloy Steel Based on Ultra-Thin Cast Strip Process

Mechanism of Improved Ductility of 1,500 MPa-class Ultra-high Strength Cold-rolled Steel Sheet Produced by Rolling and Partitioning Method

Development of TRIP-Aided Lean Duplex Stainless Steel by Twin-Roll Strip Casting and Its Deformation Mechanism

Effect of σ Phase Precipitation on the Corrosion Resistance of Fe-Cr-Mn-Al Duplex Stainless Steel

Synergistic effects of the TiC nanoparticles and cold rolling on the microstructure and mechanical properties of Al–Cu strips fabricated by twin-roll casting

Fabrication and properties of strip casting 4.5 wt% Si steel thin sheet

Strengthening Effect of Nanoscale Precipitation and Transformation Induced Plasticity in a Hot Rolled Copper-Containing Ferrite-Based Lightweight Steel

Microstructure Characteristics and Strengthening Behavior of Cu-Bearing Non-Oriented Silicon Steel: Conventional Process versus Strip Casting