On the Formation of P-Rich Surface Layer of Twin-Roll Cast High-P Strip

QIU Yi-qing,ZHOU Guo-ping,LIU Zhen-yu,WANG Guo-dong
DOI: https://doi.org/10.3969/j.issn.1005-3026.2010.08.011
2010-01-01
Abstract:To take further the advantage of the solute-rich surface layer of twin-roll cast high-P steel strip,the causes for the formation of the P-rich surface layer were discussed.Experimental results indicated that there will be a P-rich layer nearby the surface of the higher-P strip after controlling the processing parameters,but the distribution of phosphorus is basically uniform in the lower-P strip under the same conditions.Theoretical analysis showed that the rolling force may drive the interdendritic P-rich liquid metal back onto the strip surface,thus resulting in the formation of the P-rich layer in the strip under the preconditions that the kiss point takes place above the bite and the cross-section temperature of the nearby region below the kiss point is between the liquidus and solidus temperature.
What problem does this paper attempt to address?