Abstract:The solidification control is of extreme importance, because it strongly affects the final casting quality sanity. The structure obtained is generally not homogeneous and gives rise to great variations in composition, with position at small and large scales, which is known as segregation. An understanding of the way segregation occurs in continuous casting is of great importance for steels and in designing post-casting processes. As-cast structures are responsible the reduction in both scale and extension of segregation, because mass transport is dependent on the time required to diffuse a solute over a characteristic distance, e.g., the dendrite spacing that the characterizes the solidification structure. In this work, the effect of pouring temperature in steel slabs on the continuous casting processes are systematically investigated. Relationships between pouring temperature (PT) and center macrosegregation was qualitatively examined. Photomicrographs of specimen taken from transverse sections of steel slabs, shows that macrosegregation is strongly affected by pouring temperature (PT). For solute of carbon, phosphorus and sulfur, has been shown that the pouring temperature (PT) has a significant role on the resulting macrosegregation profiles, while that the elements as such silicon, manganese and aluminum, the said thermal parameter seems not able to affect its macrosegregation profiles. This is due to the fact that the solutes with lower partition coefficients favors segregation during the continuous casting process. It is shown for considered steels, the pouring temperature (PT) influences the position of the columnar to equiaxed transition (CET). Experimental results show that the end of the columnar region is abbreviated when lower pouring temperatures is used in continuous casting process. One can observe that as the pouring temperature (PT) increase in continuous casting process, the secondary dendritic arm spacing (λ2) increase, i.e., the dendritic morphology became coarsen.

Effect of Continuous Casting Technology on Low-Alloy Steel Structure in Different Production Stages

Solidification Structure of Low Carbon Steel Strips with Different Phosphorus Contents Produced by Strip Casting

Modeling and Control of Dynamic Soft Reduction in Continuous Slab Casting

Application Situation of Soft Reduction During Process of Slab Continuous Casting

Effect of soft reduction process on segregation of a 400 mm thick high-alloy steel slab

Analysis of Internal Cracks in Continuous Casting Slabs with Soft Reduction

Influence of Cast Structure Parameters on Ductility Properties of Low-Carbon Microalloyed Steels

Development of Thin Slab Continuous Casting-Direct Rolling Process and Microalloyed High Strength Steel

In situ observation and investigation of effect of cooling rate on slab surface microstructure evolution in microalloyed steel

An Experimental Investigation of Continuous Casting Process: Effect of Pouring Temperatures on the Macrosegregation and Macrostructure in Steel Slab

Investigation on the effect of reduction process on internal quality of high carbon steel billet and its evolution in as-rolled wire rod

Analysis of Longitudinal Cracking and Mold Flux Optimization in High-Speed Continuous Casting of Hyper-Peritectic Steel Thin Slabs

Research Status of High-Manganese High-Aluminum Steel and Key Points of Continuous Casting

The Influence of Thermomechanical Conditions on the Hot Ductility of Continuously Cast Microalloyed Steels

Alleviation Of Internal Cracks In Continuous Casting Bloom Of Steel 100cr6 Induced By Soft Reduction Process

The Microstructure Formation in Slag Solidification at Continuous Casting Mold

Continuous Casting Mould for Square Steel Billet Optimised by Solidification Shrinkage Simulation

Study on microsegregation model and MnS precipitation behavior of continuous casting ultra-low sulfur steel slab

INFLUENCE OF INTERNAL CRACKING ON CARBIDE PRECIPITATION IN CONTINUOUS CASTING BLOOM INDUCED BY SOFT REDUCTION TECHNOLOGY AND THE RESULTING SEGREGATED BAND IN HOT-ROLLED WIRE RODS

Effect of Grade on Thermal–Mechanical Behavior of Steel During Initial Solidification

Homogenization Path Based on 250 mm × 280 mm Bloom under Mixed Light and Heavy Presses: Simulation and Industrial Studies