Enhanced Electroluminescence from Silicon-Based Light-Emitting Devices with Mg0.4zn0.6o/Erbium-Doped Zno Heterostructures by Using Ito/Moo3 Combined Anode

Chengtao Xia,Ran Ji,Shuming Jiang,Xiaodong Zhu,Anchen Tang,Deren Yang,Xiangyang Ma
DOI: https://doi.org/10.1016/j.apsusc.2024.161782
IF: 6.7
2025-01-01
Applied Surface Science
Abstract:We have realized the erbium (Er)-related visible and near-infrared (NIR) electroluminescence (EL) from the Mg0.4Zn0.6O/ZnO:Er/n+-Si heterostructured light-emitting device (LED) using the semi-transparent Au film as the anode, where the impact-excitation of Er3+ ions is enabled by hot holes that are generated in the Mg0.4Zn0.6O acceleration layer. However, it remains a challenge to simultaneously achieve more efficient injection of holes into Mg0.4Zn0.6O layer and stronger light emanation for the Mg0.4Zn0.6O/ZnO:Er/n+-Si heterostructured LED. Addressing this issue, we report on the substitution of an ITO/MoO3 combined anode for the Au anode in the aforementioned LED to enhance the EL. Through the optimization of MoO3 film thickness, the substitution of ITO/MoO3 combined anode for Au anode leads to the enhanced EL from the Mg0.4Zn0.6O/ZnO:Er/n+-Si heterostructured LED with a factor of more than 5 in the visible region and with a factor of more than 13 in the NIR region. The higher transmittances and larger refraction indices in both visible and NIR regions and the better hole-injection capability of the ITO/MoO3 combined anode, with respect to those of Au anode, are responsible for the significantly enhanced EL as mentioned above. This work sheds light on the application of ITO/MoO3 combined anode into all-inorganic LEDs.
What problem does this paper attempt to address?