Abstract:To reduce the negative effects of the long-time and B2O3 phase on the traditional sintering process for B4C-based composite ceramics, nearly fully dense B4C–VB2 composite ceramics were prepared by reactive spark plasma sintering (SPS) technology at 2000 °C with B and V8C7 powders as raw materials in this paper. The effects of the degassing time during SPS on the microstructure and the mechanical properties of the final products were investigated in detail. The results revealed that the proper degassing time was beneficial for the vent of B2O3 during the sintering process, which refined the grain size, promoted densification and improved the mechanical properties of the composite ceramic. However, the redundant degassing time increased the holding time at high temperature, resulting in abnormal grain growth and mechanical performance deterioration. In the present work, the optimal degassing time was 6 min, and the final product prepared under the above conditions exhibited excellent comprehensive performance with a relative density of 99.2%, Vickers hardness of 31.2 GPa, bending strength of 654 MPa and fracture toughness of 5.7 MPa m1/2. In addition, the strengthening and toughening mechanisms of the products were mainly attributed to the residual thermal stresses and bridging structure caused by the fine B4C and VB2 grains distributed uniformly.

Ultrafast Pressure Sintering of B4C-based Composites Via Direct Joule Heating

Microstructures and mechanical properties of B4C‐SiC and B4C‐SiC‐TiB2 ceramic composites fabricated by hot pressing

Preparation of dense B4C ceramics by spark plasma sintering of high-purity nanoparticles

High hardness and high fracture toughness B4C-diamond ceramics obtained by high-pressure sintering

High-pressure Synthesis of Tungsten Carbide–cubic Boron Nitride (wc–cbn) Composites: Effect of Cbn Particle Size and Volume Fraction on Their Microstructure and Properties

Densification and strengthening mechanism in spark plasma sintering of B4C–VB2 ceramics via carbide boronizing

Rapid densification and mechanical properties of ultra-high-pressure sintered transition metal carbide ceramics

Enhancing densification rate and the unusual 4H-SiC polytype stabilization in ultrafast high-temperature sintering of α-SiC

Hard and tough ultrafine-grained B4C-cBN composites prepared by high-pressure sintering

High-performance B4C matrix composites fabricated from the B4C–Si–CeO2 system via reactive hot pressing

Ultra-fast high-temperature synthesis and densification of high-entropy diborides and diboride-carbide ceramics

Effect of Ti and its compounds on the mechanical properties and microstructure of B4C ceramics fabricated via pressureless sintering

Cr3C2 assisted ultrafast high-temperature sintering of TiC

Enhancement mechanical properties of in-situ preparated B4C-based composites with small amount of (Ti3SiC2+Si)

Processing and mechanical properties of B4C-SiCw ceramics densified by spark plasma sintering

Microstructure and mechanical properties of B4C–TiB2 ceramic composites prepared via a two-step method

Microstructure and mechanical properties of TiB2–B4C ceramics fabricated by hot-pressing

Sintering mechanism of pure B4C ceramic prepared by hot oscillating pressing and with excellent mechanical properties

Toughening mechanism of B4C/TiB2 ceramic materials by in situ reaction via spark plasma sintering

Effect of B4C particle size and TiB2 content on the mechanical properties of B4C composites and their dynamic mechanical properties

B4C-based hard and tough ceramics densified via spark plasma sintering using a novel Mg2Si sintering aid