Abstract:The inverter-fed motor is a key component of environmental-friendly hybrid cars, high-speed trains, and other industrial applications. After the widespread use of inverter-fed motors, the repetitive impulse surges from inverters were found to cause new insulation problems in inverter-fed motors that were linked to premature insulation failure. The partial discharge (PD) induced by the overvoltage inner stator windings was found to be the root cause of insulation reliability problems. To mitigate this problem, PD detection and life testing at repetitive square voltages should be performed on new types of insulation models and entire motor insulation systems. The obtained partial discharge inception voltage (PDIV) and lifetime of insulation in the tests can be used to evaluate the insulation status of inverter-fed motor insulation systems and thus to improve the insulation designs. At AC voltage conditions, the voltage frequency can significantly affect PD activity. At repetitive square voltage with rapid rise time, the influence of the square voltage frequency on PD activity should be investigated (1) to suggest values for the repetitive square voltage frequency selection for the PDIV and lifetime tests, and (2) to increase the signal-to-noise ratio when extracting PD pulses from strong disturbances generated by the operating switch of impulse generators. Therefore, the main purpose of this paper was to investigate the effects of repetitive square voltage frequency on PD events. Insulation models of both Type I (low-voltage inverter-fed motor) and Type II (high-voltage inverter-fed motor) were used to obtain single-PD and multi-PD statistical features, respectively. Experimental results indicated that higher frequencies caused less PD events with lower PD magnitudes and shorter delay times in one square voltage cycle. This phenomenon was attributed to the different surface charge decay ratios and the initial electron emission probabilities resulting from different square voltage frequencies. Finally, a number of considerations for PD measurements on inverter-fed motors were provided to improve the sensitivity of the PD test system and to obtain high objective insulation lifetime test results, which are used to assess the insulation status of inverter-fed motors.

Combined Effect of Short Rise Time and Relative Humidity on the Partial Discharge Inception Mechanism in Rotating Electrical Machines Insulation

Partial Discharge Investigation under Humidity Conditions Via Dissipation Factor and Insulation Capacitance Tip-Up Test

Determination of Dominant Influencing Factors on Partial Discharge Inception Voltage

Investigation on Combined Effect of Humidity–temperature on Partial Discharge Through Dielectric Performance Evaluation

Effect of Test Voltage Waveforms on Partial Discharge Inception Voltage Considering Different Environmental Conditions

Investigation on Humidity Effect on Partial Discharge Considering Thermal Aging

Effect of Repetitive Square Voltage Frequency on Partial Discharge Features

Partial Discharge Characteristics of Interturn Insulation Used for Inverter-Fed Traction Motor under Bipolar Impulses

Reliability vs. Performances of Electrical Machines: Partial Discharges Issue

Derivation of Ambient Enhancement Factors of Impregnated Twisted pairs for Partial Discharge Risk Evaluation

Inverter-Embedded Partial Discharge Testing for Reliability Enhancement of Stator Winding Insulation in Low Voltage Machines

Partial Discharge Characteristics in Oil-Paper Insulation under Combined Ac-Dc Voltage

Partial Discharge Activity of Inter-turn Insulation under Different Parameters of Square Wave Voltage

Partial Discharge Detection and Assessment of Surface defects under Fast Rising Repetitive Square Voltage for MV Converter Application

Partial Discharge Characteristics of Insulation Used in Inverter-fed Traction Motor under High Frequency Impulse

Characterizations of Partial Discharge in Modern Power Electronics

New Tools To Determine The Partial Discharges Of Inverter Fed Motor

Partial Discharge Patterns of Oil-Paper Insulation under AC Voltage Superimposed Harmonics

Fillet Radius Impact of Rectangular Insulated Wires on PDIV for Turn-to-Turn Insulation of Inverter-Fed Motors

Measurement and Analysis of Partial Discharge under High Voltage Continuous Impulses for Inverter-fed Insulation

Space-Charge Accumulation and Its Impact on High-Voltage Power Module Partial Discharge Under DC and PWM Waves: Testing and Modeling