Abstract:Partial discharge measurement plays an important role in the assessment of insulation status and fault diagnosis of power equipment. Presently, the most commonly used industrial applications of PD detections are based on the broadband measurement systems that count amplified PD pulses. The limitations of these traditional measurements are that the system requires a relatively high sampling rate and calculation capability, and is very sensitive to the ambient noise. To eliminate noise interference and save the cost of PD detection system, a technique measurement of excess currents, which measures the dielectric response currents through test object before and after PD activities to capture the activities of PD, has been reported in some recent studies. This work aims to explore the parameters that characterize the PD activities via excess current technology and to seek new ideas for PD detection. In this work, a measurement setup for measurement of PD excess currents averaged from 300 periods is applied and three typical insulation defect models were tested under 50Hz voltages. Excess currents for each case are measured. Then the corresponding dielectric loss factors and circuit impedances are obtained by comparing them to the synchronous voltages. The results show that the loss factors increase after PD while the circuit impedances decrease. Meanwhile, the loss factors continue to increase and the circuit impedances continue to decrease as the voltages turn up where the rate of the change shows more rapid in the needle-plate model. Moreover, the loss factors and circuit impedances in the dielectric barrier model and air void model are respectively higher and lower than the values before PD when the voltages drop below the PD extinction voltages, which does not appear in the needle-plate model. These characteristics provide a new idea for PD detection by monitoring the loss factors or circuit impedances via excess current detection.

Derivation of Ambient Enhancement Factors of Impregnated Twisted pairs for Partial Discharge Risk Evaluation

Effect of Test Voltage Waveforms on Partial Discharge Inception Voltage Considering Different Environmental Conditions

Estimation of the Partial Discharge Inception Voltage of Electrical Asset Components at Variable Environmental Pressure: A Modelling Approach

Determination of Dominant Influencing Factors on Partial Discharge Inception Voltage

Moving Toward Partial Discharge-Free Design of Electrical Machines for More Electric Aircraft Applications

Partial Discharge Investigation under Humidity Conditions Via Dissipation Factor and Insulation Capacitance Tip-Up Test

Investigation on Combined Effect of Humidity–temperature on Partial Discharge Through Dielectric Performance Evaluation

Fillet Radius Impact of Rectangular Insulated Wires on PDIV for Turn-to-Turn Insulation of Inverter-Fed Motors

Lifetime Model for Inverter-fed Electrical Machines Windings Including Thermal Aging and Partial Discharge Risk

Investigation on Humidity Effect on Partial Discharge Considering Thermal Aging

Lifetime Estimation of Corona-Resistance Wire for Electrical Machines Operating under the Partial Discharge Regime

Combined Effect of Short Rise Time and Relative Humidity on the Partial Discharge Inception Mechanism in Rotating Electrical Machines Insulation

Dielectric Loss Factor and Circuit Impedance under Partial Discharge Via Excess Current Detection

Temperature‐dependent partial discharge characteristics of high temperature materials at DC voltage for hybrid propulsion systems

On the influence of humidity on the breakdown strength of air—with a case study on the PDIV of contacting enameled wire pairs

Near-field Partial Discharge Measurement Technology and Application in Rotating Machine Winding Under External Induced Impulse Voltage

Investigation of partial discharge characteristics in XLPE cable insulation under increasing electrical stress

On the Frequency Dependence of the PDIV in Twisted Pair Magnet Wire Analogy in Humid Air

Partial Discharge Characteristics in Oil-Paper Insulation under Combined Ac-Dc Voltage

Evolution of Partial Discharge of Oil-Paper Insulation under Long-Term AC Voltage

Negative Medium-Voltage Direct Current Discharges in Air under Simulated Sub-Atmospheric Pressures for All-Electric Aircraft