Abstract:The inverter-fed motor is a key component of environmental-friendly hybrid cars, high-speed trains, and other industrial applications. After the widespread use of inverter-fed motors, the repetitive impulse surges from inverters were found to cause new insulation problems in inverter-fed motors that were linked to premature insulation failure. The partial discharge (PD) induced by the overvoltage inner stator windings was found to be the root cause of insulation reliability problems. To mitigate this problem, PD detection and life testing at repetitive square voltages should be performed on new types of insulation models and entire motor insulation systems. The obtained partial discharge inception voltage (PDIV) and lifetime of insulation in the tests can be used to evaluate the insulation status of inverter-fed motor insulation systems and thus to improve the insulation designs. At AC voltage conditions, the voltage frequency can significantly affect PD activity. At repetitive square voltage with rapid rise time, the influence of the square voltage frequency on PD activity should be investigated (1) to suggest values for the repetitive square voltage frequency selection for the PDIV and lifetime tests, and (2) to increase the signal-to-noise ratio when extracting PD pulses from strong disturbances generated by the operating switch of impulse generators. Therefore, the main purpose of this paper was to investigate the effects of repetitive square voltage frequency on PD events. Insulation models of both Type I (low-voltage inverter-fed motor) and Type II (high-voltage inverter-fed motor) were used to obtain single-PD and multi-PD statistical features, respectively. Experimental results indicated that higher frequencies caused less PD events with lower PD magnitudes and shorter delay times in one square voltage cycle. This phenomenon was attributed to the different surface charge decay ratios and the initial electron emission probabilities resulting from different square voltage frequencies. Finally, a number of considerations for PD measurements on inverter-fed motors were provided to improve the sensitivity of the PD test system and to obtain high objective insulation lifetime test results, which are used to assess the insulation status of inverter-fed motors.

Fillet Radius Impact of Rectangular Insulated Wires on PDIV for Turn-to-Turn Insulation of Inverter-Fed Motors

Derivation of Ambient Enhancement Factors of Impregnated Twisted pairs for Partial Discharge Risk Evaluation

Effect of Repetitive Square Voltage Frequency on Partial Discharge Features

Study of Partial Discharge Characteristics at Repetitive Square Voltages Based on UHF Method

On the Frequency Dependence of the PDIV in Twisted Pair Magnet Wire Analogy in Humid Air

PD Electromagnetic Emission of Turn-to-turn Insulation in Inverter-fed Motor

Inverter-Embedded Partial Discharge Testing for Reliability Enhancement of Stator Winding Insulation in Low Voltage Machines

Partial Discharge Investigation under Humidity Conditions Via Dissipation Factor and Insulation Capacitance Tip-Up Test

Lifetime Model for Inverter-fed Electrical Machines Windings Including Thermal Aging and Partial Discharge Risk

Study on PD Damage Mechanism of Nano-composite Used as Turn Insulation in Inverter-Fed Traction Motors

PD Characteristics and Microscopic Analysis of Polyimide Film Used As Turn Insulation in Inverter-Fed Motor

The Design Of Automatic Test System Used For Pdiv Measurement Of Inverter-Fed Motor

Combined Effect of Short Rise Time and Relative Humidity on the Partial Discharge Inception Mechanism in Rotating Electrical Machines Insulation

Partial Discharge Activity of Inter-turn Insulation under Different Parameters of Square Wave Voltage

Determination of Dominant Influencing Factors on Partial Discharge Inception Voltage

Insulation Design of a High Frequency Electrical Machine for More Electric Aircraft Propulsion

Prediction of Partial Discharge Inception Voltage for Electric Vehicle Motor Insulation Using Deep Learning

Effect of Test Voltage Waveforms on Partial Discharge Inception Voltage Considering Different Environmental Conditions

Diagnostic Method of Inter-turn Void Defect in Rotating Machine Insulation Based on PD Detection at Induced Impulse Voltage

Near-field Partial Discharge Measurement Technology and Application in Rotating Machine Winding Under External Induced Impulse Voltage

Insulation Failure of Inter-Turn Insulation in Inverter-Fed Traction Motor