Abstract:The increasing presence of HVDC (High Voltage Direct Current) links and MVDC (Medium Voltage Direct Current) connections in transmission networks needs an in-depth knowledge of the mechanisms that could affect life and reliability of electrical asset components. As for all electrical systems in general, a crucial factor affecting availability of a HVDC asset is the insulation system reliability. One of the most common causes of premature electrical failure of asset components is electrical insulation breakdown or loss of serviceability. MV/HV extrinsic accelerated aging of organic insulation is mainly due to partial discharges (PD). Their presence, even if not promoting immediate breakdown, is almost a certain cause of apparatus life not matching specifications. This paper focuses on energizations on HVDC insulation systems, and, in general, supply voltage variations, which could be affected by PD due to manufacturing, laying, interface, or structural defects (as butt gaps). To minimize PD inception risk, a theory-driven, stepwise voltage application concept is proposed. The basic idea arises from the consideration that the factor playing a key role in PD inception is the jump voltage, and the electric field distribution in insulation during voltage transients is driven by permittivity (capacitance). Thus, energizing an insulation system with a first step lower than the partial discharge inception voltage in AC ( ) and then growing voltage by smaller steps minimizing jump voltage would allow almost PD-free operation (apart from the risk of low-repetition PD at DC steady state if nominal voltage exceeds ). The effectiveness of this approach is proved by means of tests carried out on a simple test object consisting of flat XLPE (Crossed Linked Polyethylene) specimens with electrodes designed to cause surface PD, having available an innovative PD detection system which performs automatically and effectively both during voltage transients and in DC steady-state conditions. The experimental results show that the stepwise voltage energization, compared to the single step energization, could decrease significantly the number and magnitude of detected PD during energization transients, leading therefore the reduction of one order of magnitude of PD associated energy and relevant damage.

Effect of Test Voltage Waveforms on Partial Discharge Inception Voltage Considering Different Environmental Conditions

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Derivation of Ambient Enhancement Factors of Impregnated Twisted pairs for Partial Discharge Risk Evaluation

Combined Effect of Short Rise Time and Relative Humidity on the Partial Discharge Inception Mechanism in Rotating Electrical Machines Insulation

Estimation of the Partial Discharge Inception Voltage of Electrical Asset Components at Variable Environmental Pressure: A Modelling Approach

Inverter-Embedded Partial Discharge Testing for Reliability Enhancement of Stator Winding Insulation in Low Voltage Machines

Lifetime Model for Inverter-fed Electrical Machines Windings Including Thermal Aging and Partial Discharge Risk

Investigating Optimal Approaches for Energizations of DC Systems: The Stepwise Technique

Partial discharge theory and technologies related to medium-voltage electrical equipment

Effect of Temperature on Partial Discharge Properties of Polyimide Film Under Continuous Square Impulse Voltage

Partial Discharge Characteristics in Oil-Paper Insulation under Combined Ac-Dc Voltage

Measurement and Simulation of Partial Discharge in Oil-Paper Insulation under the Combined AC–DC Voltage

Space-Charge Accumulation and Its Impact on High-Voltage Power Module Partial Discharge Under DC and PWM Waves: Testing and Modeling

Partial Discharge Characteristics of Typical Insulation Defect under AC and Impulse Superimposed Voltage in SF6 Gas

Impact of impulse voltage frequency on the partial discharge characteristic of electric vehicles motor insulation

Partial discharge modeling with increasing applied voltages across different void sizes

Review of Partial Discharge Activity Considering Very-Low Frequency and Damped Applied Voltage

Effects of Low Pressure Condition on Partial Discharges in WBG Power Electronics Modules

Influence of temperature to developing processes of surface discharges in oil-paper insulation

Temperature‐dependent partial discharge characteristics of high temperature materials at DC voltage for hybrid propulsion systems

Fillet Radius Impact of Rectangular Insulated Wires on PDIV for Turn-to-Turn Insulation of Inverter-Fed Motors