Abstract:This paper deals with the Cu-nanowire-based bonding technology for the fine-pitch interconnects. This Nano-material based bonding is a viable alternative to current state of the art Cu-SiO2 (oxide-oxide) hybrid bonding which is basically applicable for wafer-to-wafer bonding with fine-pitch interconnects for 3D integration. But as this technology exhibits cleaning challenges and surface preparation issues on die level, i.e. die-to-die (D2D) and die-to-wafer (D2W) assembly. Therefore, in order to overcome these challenges on die level, another substitute method for direct Cu/Cu bonding using Cu nanowires is investigated. Since Cu is the standard interconnect material, nanostructured Cu pads/bumps are desirable. In particular nanowires are interesting because an additional layer with Cu nanowires is selectively grown on top of regular Cu microbumps, thus enabling the bonding under room temperature. The initial mechanical connection at the interface is achieved by applying certain pressure during the D2D placement. Smaller pressures are required compared to TCB due to less dense structures. Hence this pressure allows nanowires to merge into each other and stay mechanically connected. Later annealing is done to attain the solid Cu/Cu joint. In this work we have investigated D2D bonding with top and bottom dies containing the Cu microbumps with nanowires. In this work, most importantly the technological parameters such as different nanowire thickness involving Ø 200nm and Ø 400 nm wires and different annealing temperatures i.e. 150 °C, 250 °C, and 350 °C were tested post bonding.

A Novel Low-temperature Co-Co Direct Bonding for Future 3D Interconnection

Enhanced Cu-Cu bonding for ultrahigh-density interconnection: Co passivation bonding with non-oxidation interfaces

Low Contact Resistance Copper-Copper Bonding with Selective Electroless Plating Cobalt Interlayer

Development of low temperature Cu Cu bonding and hybrid bonding for three-dimensional integrated circuits (3D IC)

Low-temperature copper-copper quasi-direct bonding with cobalt passivation layer

Influence of Bonding Conditions on Low-temperature Solid-state Bonding of Cobalt Based Nanocones

Low-temperature Cu/SiO2 Hybrid Bonding Using a Novel Two-Step Cooperative Surface Activation

Cu-Based Thermocompression Bonding and Cu/Dielectric Hybrid Bonding for Three-Dimensional Integrated Circuits (3D ICs) Application

Low-temperature Cu Cu Direct Bonding with Ultra-Large Grains Using Highly (110)-Oriented Nanotwinned Copper

Low temperature solid-state-diffusion bonding for fine-pitch Cu/Sn/Cu interconnect

Novel Cu-nanowire-based technology enabling fine pitch interconnects for 2.5D/3D Integration

Metallurgical aspects and joint properties of Cu-Ni-In-Cu fine-pitch interconnects for 3D integration

Synergistic enhancement of adhesion and electromigration reliability of cobalt via super-diluted (0.06 at.%) tungsten alloying as next-generation interconnect materials

A Novel Low- Temperature Cu/SiO2 Hybrid Bonding Based on Functional Group Selective Construction

Thermal instability of nanocrystalline Cu enables Cu-Cu direct bonding in interconnects at low temperature

Mechanism Of Low Temperature Cu-In Solid-Liquid Interdiffusion Bonding In 3d Package

Developments of copper-to-copper low temperature bonding technology for 3D packaging

Low-Temperature Bonding Method Based on Metallic Microcone Array for Interconnection Application

Interfacial Characterization of Low-Temperature Cu-to-Cu Direct Bonding with Chemical Mechanical Planarized Nanotwinned Cu Films

Solid-State-Diffusion Bonding for Wafer-Level Fine-Pitch Cu/Sn/Cu Interconnect in 3-D Integration

A Low-Temperature Cu-to-Cu Interconnection Method by Using Nanoporous Cu Fabricated by Dealloying Electroplated Cu–Zn