Abstract:AgSbSe2 is a typical member of cubic I–V–VI2 semiconductors, which are known for their extremely low lattice thermal conductivity (κl). However, the low electrical conductivity of AgSbSe2, below ∼10 S cm–1 at room temperature, has hindered its thermoelectric performance. In this work, single-phase AgSbSe2 bulk samples with much higher electrical conductivity were synthesized via self-propagating high-temperature synthesis (SHS) combined with spark plasma sintering (SPS) for the first time. Pb doping through the nonequilibrium process further increases the electrical conductivity to >100 S cm–1. Furthermore, continuously increased effective mass md* can be achieved upon Pb doping because of the multiple degenerate valence bands of AgSbSe2 and the energy-filtering effect induced by in situ-formed nanodots. The simultaneous enhancement of both the electrical conductivity and Seebeck coefficient contributes to an unprecedentedly high average power factor of 6.75 μW cm–1 K–2. Meanwhile, the introduced dense grain boundaries and point defects enhance the phonon scattering and consequently suppress κl, yielding a high ZT value of 1.2 at 723 K in AgSb0.94Pb0.06Se2. This study opens a new avenue for rapid, low-cost, large-scale production of AgSbSe2-based materials and demonstrates that Pb-doped AgSbSe2 prepared via the SHS–SPS method is a promising candidate for thermoelectric applications.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.0c10508?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.0c10508</a>.Part of the thermoelectric properties of AgSb1–xPbxSe2, temperature-dependent electronic thermal conductivity, Lorentz constant, diffusivity, heat capacity, and the elemental quantitative analysis by EPMA for AgSb1–xPbxSe2 (<a class="ext-link" href="/doi/suppl/10.1021/acsami.0c10508/suppl_file/am0c10508_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

The New Thermoelectric Semiconductors Pb5Sb12+xBi6−xSe32 with Ultralow Thermal Conductivity

Crystal Structure and Thermoelectric Properties of Pavonite Homologous Pb4Sb12–xBi8+xSe34

Crystal Structure and Thermoelectric Properties of Pavonite Homologous Pb4Sb12-x Bi8+x Se34

Pb m Bi 2 S 3+ m Homologous Series with Low Thermal Conductivity Prepared by the Solution-Based Method as Promising Thermoelectric Materials

High Thermoelectric Performance of AgSb 1– x Pb x Se 2 Prepared by Fast Nonequilibrium Synthesis

High Thermoelectric Performance of AgSb1-xPbxSe2 Prepared by Fast Non-Equilibrium Synthesis.

Superior thermoelectric performance in PbTe-PbS pseudo-binary: extremely low thermal conductivity and modulated carrier concentration

Bi8Se7: Delocalized Interlayer π-Bond Interactions Enhancing Carrier Mobility and Thermoelectric Performance near Room Temperature

CuPbBi<sub>5</sub>S<sub>9</sub> thermoelectric material with an intrinsic low thermal conductivity: Synthesis and properties

Realization of an ultra-low lattice thermal conductivity in Bi2AgxSe3 nanostructures for enhanced thermoelectric performance

Ultralow Thermal Conductivity of a Chalcogenide System Pt3Bi4Q9 (Q = S, Se) Driven by the Hierarchy of Rigid [Pt6Q12]12- Clusters Embedded in Soft Bi-Q Sublattice

Lattice Plainification Leads to High Thermoelectric Performance of P-Type PbSe Crystals

Planar Zintl-phase high-temperature thermoelectric materials XCuSb (X = Ca, Sr, Ba) with low lattice thermal conductivity

Synergistically optimized electron and phonon transport of p-type BiCuSeO oxyselenides via Pb dopant and Te composite

Multiple Converged Conduction Bands in K2bi8se13: A Promising Thermoelectric Material with Extremely Low Thermal Conductivity

Optimizing thermoelectric properties of BiSe through Cu additive enhanced effective mass and phonon scattering

Quasi-layered Crystal Structure Coupled with Point Defects Leading to Ultralow Lattice Thermal Conductivity in n-Type Cu 2.83 Bi 10 Se 16

Ultralow lattice thermal conductivity and enhanced power generation efficiency realized in Bi2Te2.7Se0.3/Bi2S3 nanocomposites

High Thermoelectric Performance of a Novel Γ-Pbsnx2 (X = S, Se, Te) Monolayer: Predicted Using First Principles

Low lattice thermal conductivities and good thermoelectric performance of hexagonal antiperovskites X(Ba & Sr)3BiN with quartic anharmonicity

Ultralow Thermal Conductivity and Enhanced Figure of Merit for CuSbSe 2 via Cd-Doping