Abstract:CaMg 2 Bi 2 -based compounds, a kind of the representative compounds of Zintl phases, have uniquely inherent layered structure and hence are considered to be potential thermoelectric materials. Generally, alloying is a traditional and effective way to reduce the lattice thermal conductivity through the mass and strain field fluctuation between host and guest atoms. The cation sites have very few contributions to the band structure around the fermi level; thus, cation substitution may have negligible influence on the electric transport properties. What is more, widespread application of thermoelectric materials not only desires high Z T value but also calls for low-cost and environmentally benign constituent elements. Here, Ba substitution on cation site achieves a sharp reduction in lattice thermal conductivity through enhanced point defects scattering without the obvious sacrifice of high carrier mobility, and thus improves thermoelectric properties. Then, by combining further enhanced phonon scattering caused by isoelectronic substitution of Zn on the Mg site, an extraordinarily low lattice thermal conductivity of 0.51 W m -1 K -1 at 873 K is achieved in (Ca 0.75 Ba 0.25 ) 0.995 Na 0.005 Mg 1.95 Zn 0.05 Bi 1.98 alloy, approaching the amorphous limit. Such maintenance of high mobility and realization of ultralow lattice thermal conductivity synergistically result in broadly improvement of the quality factor β . Finally, a maximum Z T of 1.25 at 873 K and the corresponding Z T a v e up to 0.85 from 300 K to 873 K have been obtained for the same composition, meanwhile possessing temperature independent compatibility factor. To our knowledge, the current Z T a v e exceeds all the reported values in AMg 2 Bi 2 -based compounds so far. Furthermore, the low-cost and environment-friendly characteristic plus excellent thermoelectric performance also make the present Zintl phase CaMg 2 Bi 2 more competitive in practical application.

Planar Zintl-phase high-temperature thermoelectric materials XCuSb (X = Ca, Sr, Ba) with low lattice thermal conductivity

Achieving High Thermoelectric Performance in Rare-Earth Element-Free CaMg 2 Bi 2 with High Carrier Mobility and Ultralow Lattice Thermal Conductivity

First-Principles Thermoelectric Study of SrMgSi and CaMgGe Zintl-Phase Compounds

Enhancing thermoelectric performance of AB 2 Sb 2 -type Zintl phase through band shaping and lattice distortion

Zintl-phase Eu2ZnSb2: A promising thermoelectric material with ultralow thermal conductivity

Zintl Phase Yb 1– x Ba x Mg 2 Bi 1.98 Compounds with Enhanced Thermoelectric Performance Caused by Cation Substitution

In-Plane Overdamping and Out-Plane Localized Vibration Contribute to Ultralow Lattice Thermal Conductivity of Zintl Phase KCdSb

Low Lattice Thermal Conductivity-Driven Promising Thermoelectric Figure of Merit in NaSrSb and NaBaSb Zintl Phases

Realizing high thermoelectric performance in p-type CaZn2Sb2-alloyed Mg3Sb2-based materials via band and point defect engineering

Enhanced Thermoelectric Performance of Zintl Phase Ca9Zn4+ xSb9 by Beneficial Disorder on the Selective Cationic Site

High Thermoelectric Performance in Cu2SnS3 by Control Over Phase‐Dependent Mobility Edge

Promising Zintl-Phase Thermoelectric Compound SrAgSb

Weak-Bonding Elements Lead to High Thermoelectric Performance in BaSnS 3 and SrSnS 3 : A First-Principles Study

CuPbBi<sub>5</sub>S<sub>9</sub> thermoelectric material with an intrinsic low thermal conductivity: Synthesis and properties

Enhanced Thermoelectric Performance of LiZnSb-Alloyed CaZn 0.4 Ag 0.2 Sb by Band Engineering

Defect Modulation on CaZn1-xAg1-ySb (0 < X < 1; 0 < Y < 1) Zintl Phases and Enhanced Thermoelectric Properties with High Zt Plateaus

Thermoelectric Zintl phases with ultralow thermal conductivity: synthesis, structural characterization, and transport properties of Ca 10 AlSb 9 and Ca 10 CdSb 9

Electronic Orbital Alignment and Hierarchical Phonon Scattering Enabling High Thermoelectric Performance p-Type Mg 3 Sb 2 Zintl Compounds

Approaching high thermoelectric performance in p-type Cu3SbS4-based materials by rational electronic and nano/microstructural engineering

Room Temperature High Thermoelectric Performance of Bi-based Full-Heusler Compounds CsxRb3-xBi with Strong Anharmonicity

A14MgBi11 (A = Ca, Sr, Eu): Magnesium Bismuth Based Zintl Phases As Potential Thermoelectric Materials