Abstract:Scan based built-in self-test (BIST), which naturally extends scan-based test methodology with test patterns applied from test equipment to BIST, can be used for the self test of sequential circuits and attain higher fault coverage. If the circuit under test (CUT) contains multiple parallel scan chains, a parallel generator is needed. Known as the common pseudo-random pattern generator (PRPG), an LFSR can be configured to generate a random pattern stream. The PRPG-based patterns may be applied to the existing scan architecture directly from the LFSR, or through some decorrelation logic. In order to attain higher fault coverage, it is very important to analyze the test pattern generation in the scan based BIST. The paper presents a kind of scheme for test pattern generation in the scan based BIST for the circuits with multiple scan chains. In the test pattern generation scheme the PRPG, which is implemented by an LFSR, shifts the sequences into all scan chains simultaneously. The correlativity weight R(M) of multiple scan chains is also defined in the paper. Based on the analysis of the different degree effect on fault coverage due to the different configuration of multiple scan chains, one conclusion is drawn that the probability that the fault coverage is reduced is increased with an increase of the correlativity weight R(M). If the circuit is tested by the multiple scan chains with the minimum R(M), the probability that the fault coverage is reduced is least. In the paper a method to construct multiple scan chains with minimum correlativity weight R(M) is proposed to overcome the bad effect on fault coverage due to the correlation between scan chains. Furthermore the minimum set of deterministic patterns is generated for hard-to-test faults by ATPG and the set is used to design the bit modifying logic circuit (BML), which is located between multiple scan chains and the CUT. Through BML the signals in multiple scan chains are controlled to input to the CUT. When the test control signal is low, the test patterns in multiple scan chains are input into the CUT directly. When the test control signal is high, the value of the signals at certain bit positions in the multiple scan chains are modified by BML and the changed test patterns are input into the CUT to test hard-to-test faults for complete fault coverage. The experiments on some ISCAS'89 benchmark circuits show that the complete fault coverage can be obtained by the test method presented by the paper. The overhead of BML is also analyzed.

Test Pattern Generation for Crosstalk-Induced Delay Faults Based on MAF Model

Fast And Effective Fault Simulation For Path Delay Faults Based On Selected Testable Paths

Analyse of Protection Devices' Speed Performance against ESD under CDM Using TCAD

Scan Testing for Complete Coverage of Path Delay Faults with Reduced Test Data Volume, Test Application Time, and Hardware Cost

New Crosstalk Avoidance Codes Based on a Novel Pattern Classification

Investigation of Turn-on Speeds of Electrostatic Discharge Protection Devices Using Transmission-Line Pulsing Technique

Test compaction for small-delay defects using an effective path selection scheme

Crosstalk and Congestion Driven Layer Assignment Algorithm

Generating Compact Robust and Non-Robust Tests for Complete Coverage of Path Delay Faults Based on Stuck-at Tests.

A New Configuration Scheme for Delay Test in Non-Simple LUT FPGA Designs

An improved method for test chip design

New Techniques for Accelerating Small Delay ATPG and Generating Compact Test Sets

Layer Assignment Algorithm For Rlc Crosstalk Minimization

Compact Test Generation for Small-Delay Defects Using Testable-Path Information

Far-End Crosstalk Mitigation for Microstrip Lines in High-Speed PCBs

Analysis of crosstalk noise in coupled MWCNT interconnects using MRTD technique

Time-Varying Pseudorandom Disturbed Pattern Generation Algorithm for Track Circuit Equipment Testing

Test Pattern Generation in Built-In Self-Test with Multiple Scan Chains

A Novel Test Application Scheme for High Transition Fault Coverage and Low Test Cost

Conflict Driven Scan Chain Configuration for High Transition Fault Coverage and Low Test Power

Test pattern generation for static burn-in based on equivalent fault model