Abstract:Because of the updated requirement on ultra-low NOx emission (<50 mg/Nm(3)), most of Chinese coal-fired boilers have to be operated at a low NOx combustion mode. However, for high-sulfur coal, water-cooled wall tubes probably suffer severe corrosion in such a strong reduction atmosphere. This work aims to investigate the high temperature corrosion behavior of water-cooled wall tubes inside a 300 MW boiler unit. A short length of corroded water-cooled wall tube was cut down and was analyzed by various characterization methods to further figure out the detailed corrosion mechanism. The typical corrosion products can be distinguished by blue, black and pale-green. Results showed that blue and black color products were mainly consisted of iron sulfides and iron oxides while the pale-green ones were identified as zinc sulfide. Along the radial direction, a layered structure of corrosion products can be observed. The formation of inner layer resulted from the reaction between iron oxide and hydrogen sulfide. The sulfur element displays a gradual increase trend while the Fe element gives out an opposite trend along the radially outward direction. The intermediate layer comes from the fly ash deposition and the outer layer is formed via condensation and deposition of ferrous sulfide gas on the water-cooled wall. The corrosion in this power plant is typical sulfide type for large amounts of Fe and S element were found in the corrosion products. (C) 2019 Energy Institute. Published by Elsevier Ltd. All rights reserved.

Safety Evaluation on Corrosion and Abrasion Situation of CFB Boiler System

Failure Analysis on Corrosion of Refeed Valve Manhole Door in Circulating Fluidized Bed Boiler

Corrosion Evaluation of One Dry Desulfurization Equipment - Circulating Fluidized Bed Boiler

Evaluation and Improvement of the Coupled Effect of High-temperature Corrosion-erosion on Water Wall Tubes

Experimental study on ash deposition and corrosion in a CFB boiler co-firing biomass with coal

Corrosive damage analysis and characterization of boiler tubes in a secondary superheater

Investigation on slagging and high-temperature corrosion prevention and control of a 1000 MW ultra supercritical double tangentially fired boiler

Research on Slagging and High Temperature Corrosion Prevention and Control of a 1 000 MW Ultra Supercritical Double Tangentially Fired Boiler

Effect of metal anti-wear device on the water wall erosion in CFB boiler

Failure Analysis Of Boiler Tubes And Research Situation Of Non-Coating Protection Technology

A Study of High-temperature Corrosion Characteristics of Coal-fired Utility Boilers

Investigation on High Temperature Corrosion of Water-Cooled Wall Tubes at a 300 MW Boiler

Research on Slagging and High Temperature Corrosion Prevention and Control of a 1000 MW Ultra Supercritical Double Tangentially Fired Boiler

Corrosion Evaluation of One Wet Desulfurization Equipment – Flue Gas Desulfurization Unit

Analysis and Solution of High-temperature Corrosion for a 1000 MW Ultra-supercritical Boiler

Research Progress in the Corrosion Mechanisms and Anticorrosion Technologies of Waste-to-Energy Plant Boilers

Effect of Fouling Layer (Acid–Ash Reaction) on Low-Temperature Corrosion Covering Heating Surface in Coal-Fired Flue Gas

Safety Analysis on the Heating Surfaces in the 660 MW Ultra-Supercritical CFB Boiler under Sudden Electricity Failure

Corrosion and Fouling of Heat Transfer Surfaces

Field Study on the Corrosion and Ash Deposition of Low-Temperature Heating Surface in a Large-Scale Coal-Fired Power Plant

Study on High Temperature Corrosion of Super Heater in MSW Combustion