Abstract:Composite ceramics of 0.7BaO center dot 0.3SrO center dot(I-gamma)TiO2 center dot gamma Nb2O5 (BSTN) with coexistence of barium strontium titanate, Ba1-xSrxTiO3 (BST), and strontium barium mobate, SrxBa1-xNb2O6 (SBN) phases were successfully prepared in situ by controlling excess components according to a specially designed formula of 0.7BaO center dot 0.3SrO center dot(1-gamma)TiO2 center dot gamma Nb2O5 and by using a traditional ceramic process. X-ray diffractometry (XRD), scanning electron microscopy (SEM) and energy dispersion spectrometer (EDS) were used to characterize the phase composition, morphology and the micro-area chemical composition of the composite ceramics. The results showed that the SBN tungsten bronze phase appeared and coexisted stably with the BST perovskite phase when the excess content of Nb2O5 was > 6mol%, whereas the BST perovsklite phase formed and coexisted stably with the SBN tungsten bronze phase when the excess content of TiO2 was > 5.3mol%. In the ease of the two phases being equivalent to each other in BSTN composite ceramics, Nb2O5 was hard to be resolved into the perovskite phase, however, a few of TiO2 was easy to be resolved in the tungsten bronze phase. The microstructure of the composite ceramics were consisted of two kinds of grains. The smaller polygonal grains were belonged to the BST phase, and the larger ones to the SBN phase. The coexistence of the two phases inhibited the growth of the BST crystal. The density of microstructure of the composite ceramic was higher than that of both the pure BST and SBN calcined at the same temperature for the same time.

Preparation and Properties of BN-SiO<sub>2</sub> Composite Ceramics

Preparation and Properties of Porous Si<sub>3</sub>N<sub>4</sub>/SiO<sub>2</sub>/BN Composite Ceramics

Preparation and properties of porous Si 3N 4/SiO 2/BN composite ceramics

Mechanical, dielectric and thermal properties of porous boron nitride/silicon oxynitride ceramic composites prepared by pressureless sintering

Fabrication and properties of porous boron nitride/silicon oxynitride ceramic composites via gas pressure sintering

In situ Preparation of BST(Nb)/SBN(Ti) Composites

Fabrication and Properties of SiO2-BN-Si3N4 Composites

Preparation and characteristics of highly porous BN-Si3N4 composite ceramics by combustion synthesis

The microstructural evolution, mechanical and dielectric properties of BNW/SiO2 ceramics

Microstructure and room/elevated-temperature mechanical properties of hot-pressed h-BN composite ceramics with La2O3-Al2O3-SiO2 addition

Microstructural evolution of h-BN matrix composite ceramics with La-Al-Si-O glass phase during hot-pressed sintering

Silicon nitride/boron nitride ceramic composites fabricated by reactive pressureless sintering

In situ synthesis of PcBN composites by Sialon combined with cBN-TiB2-AlN and their properties

Hot-press sintering studies of sol-gel-prepared composite powders: A novel preparation method to improve mechanical properties of BN-BAS composite ceramics

High-pressure Synthesis of Al2O3-cBN Composites: Effect of Thermodynamic Condition and Cbn Volume Fraction on Their Microstructure and Properties

Pressureless-sintered boron nitride nanosheets/glass composite ceramics for excellent mechanical, dielectric and thermo-conductive performances

Characterization and Microstructural Evolution of Continuous BN Ceramic Fibers Containing Amorphous Silicon Nitride

High Electrical Resistivity of Pressureless Sintered in Situ SiC–BN Composites

Microstructure and mechanical properties of h-BN–SiC ceramic composites prepared by in situ combustion synthesis

Pressureless sinterability study of ZrB2–SiC composites containing hexagonal BN and phenolic resin additives

Boron Nitride Doped Transparent Polycrystalline Silicon Nitride Ceramics

Preparation and Properties of BN-SiO&lt;sub&gt;2&lt;/sub&gt; Composite Ceramics

Preparation and Properties of Porous Si&lt;sub&gt;3&lt;/sub&gt;N&lt;sub&gt;4&lt;/sub&gt;/SiO&lt;sub&gt;2&lt;/sub&gt;/BN Composite Ceramics