Abstract:The engagement surface of the threaded connection of Oil Country Tubular Goods (OCTG) is a complex helical surface. The stress analysis of the threaded connection involves material nonlinearity, geometric nonlinearity and contact nonlinearity. It is difficult to obtain an analytical solution and the finite element method (FEM) is a powerful numerical method for solving the problem of threaded connection. Due to the complexity of three-dimensional modeling and the difficulty of computational convergence, researchers usually use two-dimensional axisymmetric finite element models to analyze the characteristic of threaded connection. However, twodimensional axisymmetric model can not efficiently simulate the stress characteristics of the threaded connection with make-up torque, which has greatly influence on the reliability of the connection, and it can not reflect the real stress state of the threaded connection. In this paper, an explicit dynamic FEM is employed and the nonlinear contact theory, nonlinear elastic-plastic stress-strain relationships and the von Mises yield criterion are considered to analyze the stress distribution of the threaded connection. As examples, three-dimensional elasto-plastic finite element models of bypass valve and drill pipe threaded connection are established. Mechanical characteristics of the threaded connections are analyzed, in which the make-up torque, axial loads and working torque are comparable with the real working conditions. It is found that the pin of bypass valve threaded connection shows a high stress and is broken when the working torque exceeds 22992.8 N center dot m. Meanwhile, drill pipe threaded connection is reliable under the most demanding load. Analysis results presented in this paper are consistent with the field observation.

Theoretic Analysis of Twisting Moment of Screw Thread

Experimental investigation of mechanical behavior of grade 8.8 and 10.9 small-sized (m14-m20) bolts with the thread into the bolt hole

ANALYSIS OF TWISTING ABOUT UPPER FLANGE OF C-SECTION PURLIN WITH TWO SAG RODS

Fine analysis of section stress of steel strand

ANALYSIS OF GLOBAL STABILITY OF C-PURLINS UNDER WIND SUCTION

Effect of Thread Design Parameters on Central Screw Loosening: A 3D Finite Element Analysis

Three-dimensional finite element analysis of tightening and loosening mechanism of threaded fastener

Dynamics and tired intensity analysis of fixed torque bolt

Nonlinear Analysis of the Threaded Connection with Three-Dimensional Finite Element Model

Study on local slippage accumulation between thread contact surfaces and novel anti-loosening thread designs under transversal vibration

Distributions of tension and torsion in a threaded connection

Analyses of Tightening Characteristics and Cyclic Stress Amplitude of Studs and Tap Bolts

Loosening and Strength Failure Calculation Models of Screwed Joints Under Complex Working Condition Loading

Experimental and computational investigations of nonlinear frictional behavior in threaded fasteners

A Novel Screw Modeling Approach to Study the Effects of Screw Parameters on Pullout Strength.

Analysis of the Tightening Process and the Cyclic Stress Amplitude of Studs and Tap Bolts

Damage Mechanism Analysis of the Connecting Screw of Turbine Disk-Drum Assembly

Study on the rate of change of thread angle and thread distance considering the interference factor under before and after the dynamic vibration of the fastening system

Concept of radial slippage propagation triggering self-loosening and optimisation design of novel anti-loosening structures

Study on Axial Deformation of Ball Screw

Stress-conversion-based Approach of High-cycle Fatigue Strength Analysis for Internal Threads