Abstract:The intermetallic compound has been widely introduced in alloys as a reinforced phase due to its high strength, high hardness and enhanced heat stability. The size, morphology, distribution and volume fraction of these intermetallic compounds affect the mechanical properties of materials significantly. In this work, the microstructures evolution and growth behoviors of primary intermetallic Al3Y phase have been investigated in directionally solidified Al-15% Y (mass fraction) hypereutectic alloy at a wide range of pulling rates (1 similar to 100 mu m/s). The ascast Al-15% Y alloy is composed of primary intermetallic Al3Y phase and Al3Y/Al eutectic structure. At relatively low pulling rates (1 similar to 5 mu m/s), primary Al3Y phase exhibits irregular and having a branching structure on the top of the specimens. Primary Al3Y phase also precipitates in a faceted growth with sharp edges and corners. As the pulling rate increases, the morphologies of Al3Y phase transit to elongated prism. Al3Y phase distributes dispersively in the eutectic structure at a higher pulling rate, presenting a crossing shape with two prisms crossed vertically. Further increasing the growth rate to 100 mu m/s, the cross morphology such as two six prismatic vertical cross structure of primary Al3Y appear, similar to the growth in the form of dendrites. During the increase of pulling rates, the leading-phase at solid-liquid interface appear gradually, and the growth distance of primary phase increases with the pulling rates increase.

Microstructural Characteristic of Α'-Aln-polytypoids Multi-phase Sialon

Effect of Rare Earth Elements on Formation Kinetics of Α'-Aln-polytypoids Dual-Phase Ceramics

Investigation on the microstructure of self-reinforced Nd-α-sialon ceramics

Microstructure of Different Rare-Earth-Doped α-Sialon Ceramics

MICROSTRUCTURE CONTROL AND MECHANICAL PROPERTIES OPTIMIZATION OF Α-Sialon CERAMICS

Synthesis and characterization of single-crystalline phase Li-α-Sialon

Synthesis And Characterization Of Single-Crystalline Phase Li-Alpha-Sialon

Influence of Processing and Microstructure on Mechanical Properties in Sialon-Based Ceramics

Characterization of the Microstructure of Sintered Aln by Sem and Tem

Microstructure and Properties of Self-Reinforced Α-Sialon Ceramics Doped with Lu2O3

RESEARCH PROGRESS OF SELF-REINFORCED Α - SIALON CERAMICS

Study on Phase Transformation and Microstructure Development of Yb Α-Sialon Ceramics Prepared by Pressureless Sintering

Preparation and formation mechanism of elongated (Ca, Dy)-α-sialon powder via carbothermal reduction and nitridation

A porous (La, Sm) co-doped Sialon-polytypoid ceramic with colour and structure differences in multilayers

Effect of Different Rare-Earth on Microstructure and Properties of alpha-Sialon Ceramics

Preparation And Formation Mechanism Of Elongated (Ca,Dy)-Alpha-Sialon Powder Via Carbothermal Reduction And Nitridation

Microstructural and mechanical characterization of pressure-less sintered aln -polytypoid based composites by compositional design

Effect of Porosity on the Structure and Properties of Β-Sialon Ceramics

Microstructure Evolution and Growth Behaviors of Faceted Phase in Directionally Solidified Al-Yalloys I. Microstructure Evolution of Directionally Solidified Al-15%Y Hypereutectic Alloy

Effect of Y‐α‐Sialon Seeding and Holding Time on the Formation of Elongated (ca,dy)‐α‐sialon Crystals Prepared Via Carbothermal Reduction and Nitridation

Synthesis of Rod-Like Α-Sialon by Carbothermal Reduction-Nitridation