Abstract:(Ca,Dy) co-stabilized a-Sialon with elongated grains was prepared from SiO2-AlN-CaF2-Dy2O3 powders by carbothermal reduction-nitridation (CRN) at 1700 degrees C. Detailed investigations on the formation process of (Ca,Dy)-alpha-Sialon elongated grains performed under various firing conditions revealed that the big quartz particles were initially reduced and decomposed gradually by carbon, and a large number of ball-shaped particles consisting of amorphous (Si,Al,Ca,Dy)x(O,N)y were formed. With increasing temperature, nitrogen continuously diffused nto the liquid to form nitrogen-rich solid balls. Further increasing the temperature to 1700 degrees C and held for 2 h, hollow alpha-Sialon spheres with nanometric particles were obtained from nitrogen-rich solid balls. Subsequently, the framework structure of hollow spheres was destroyed at 1700 degrees C for 3 h, and (Ca,Dy)-alpha-Sialon grains grew up continuously by consuming nanometric particles in the rough interface via Ostwald ripening and growth stages moving on the smooth interface. Finally, (Ca,Dy)-alpha-Sialon developed well-defined crystalline elongated grains because the growth rate of rough surfaces is more rapid than that of smooth surfaces.

Effects of Technical Parameters on the Phase Composition and Microstructure of Yb Α-Sialon Prepared by Combustion Synthesis

Effects Of Technical Parameters On The Phase Composition And Microstructure Of Yb Alpha-Sialon Prepared By Combustion Synthesis

Effect of Diluents and NH4F Additive on the Combustion Synthesis of Yb Α-Sialon

Combustion synthesis of rod-like Yb alpha-sialon powders

Effects of starting compositions on the phase composition and microstructure of Yb α-SiAlON prepared by combustion synthesis

Study on Phase Transformation and Microstructure Development of Yb Α-Sialon Ceramics Prepared by Pressureless Sintering

Combustion synthesis and sintering of rod-like Yb α-Sialon powders

Effect of NH4F and Temperature on Combustion Synthesis of Rod-Like Yb α-Sialon Powder

Novel rod-like yttrium α-sialon crystalline powders prepared by combustion synthesis

Structural Formation and Mechanism in Combustion Synthesis of Nitrogen Ceramics (AIN, Si<sub>3</sub>N<sub>4</sub> and AIN-SiC)

Combustion synthesis and sintering of rod-like Yb alpha-sialon powders

Effect of seed addition with combustion synthesized powder on pressureless sintering of Y alpha-SiAlON

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

Pressureless sintering of in-situ toughened Yb α-SiAlON ceramics by adding seed crystals prepared by combustion synthesis

Fabrication of Yb alpha-SiAlON ceramics by SPS with crystal seeds prepared through combustion synthesis

Low-temperature Preparation of in Situ Toughened Yb Α-Sialon Ceramics by Spark Plasma Sintering (SPS) with Addition of Combustion Synthesized Seed Crystals

Effect of Nitrogen Pressure and Additives on Combustion Synthesis of Rod-Like Yttrium α-SiAlON Crystals

Preparation of (ca+m) (m=mg, Yb, Sr) Co-Doped Α-Sialon Powders by Combustion Synthesis

Fabrication of (ca + Yb)- and (ca + Sr)-stabilized Α-Sialon by Combustion Synthesis

Fabrication of yttrium-stabilized α -SiAlON powders with rod-like crystals by combustion synthesis

Preparation and formation mechanism of elongated (Ca, Dy)-α-sialon powder via carbothermal reduction and nitridation