Abstract:By applying SPS technique, new Yb α-SiAlON ceramics in situ toughened by rod-like grains were prepared at a relatively low temperature of 1600°C, with combustion synthesized seed crystals added. The effects of sintering temperature, heating rate, and the addition of seed crystals on the densification process, phase transformation, microstructure development, and mechanical properties of the samples were discussed in detail. The experimental results showed that Yb α-SiAlON ceramics could be almost fully densified quickly by SPS, and the fast heating rate was helpful to reduce the amount of intermediate phases. Higher sintering temperature and appropriate holding time were beneficial to the promotion of phase transformation and grain growth. It was also demonstrated that the added seed crystals played an important role in enhancing the phase transformation and facilitating the growth of rod-like grains. Being toughened by the rod-like grains via the mechanisms such as grain pull-out and debonding, the fracture toughness of as-sintered Yb α-SiAlON ceramics with additive seed crystals was remarkably improved.

Pressureless sintering of in-situ toughened Yb α-SiAlON ceramics by adding seed crystals prepared by combustion synthesis

Effect of seed addition with combustion synthesized powder on pressureless sintering of Y alpha-SiAlON

Fabrication of Yb alpha-SiAlON ceramics by SPS with crystal seeds prepared through combustion synthesis

Low-temperature Preparation of in Situ Toughened Yb Α-Sialon Ceramics by Spark Plasma Sintering (SPS) with Addition of Combustion Synthesized Seed Crystals

Study on Phase Transformation and Microstructure Development of Yb Α-Sialon Ceramics Prepared by Pressureless Sintering

Phase transformation and microstructure development of in situ toughened Yb α-SiAlON ceramics prepared by two-step hot-pressing

Combustion synthesis and sintering of rod-like Yb α-Sialon powders

Combustion synthesis and sintering of rod-like Yb alpha-sialon powders

Preparation of tough ÃÂ¡-SiAlON ceramics by spark plasma sintering with ÃÂ¢-Si3N4 as raw materials

Pressureless sintered Al4SiC4 ceramics with Y2O3 addition

Rapid Densification and Reaction Sequences in Self-Reinforced Y-α-SiAlON Ceramics with Barium Aluminosilicate As an Additive

Effects of starting compositions on the phase composition and microstructure of Yb α-SiAlON prepared by combustion synthesis

Effects Of Technical Parameters On The Phase Composition And Microstructure Of Yb Alpha-Sialon Prepared By Combustion Synthesis

Fabrication of yttrium-stabilized α -SiAlON powders with rod-like crystals by combustion synthesis

Effect of Nitrogen Pressure and Additives on Combustion Synthesis of Rod-Like Yttrium α-SiAlON Crystals

Effect of Diluents and NH4F Additive on the Combustion Synthesis of Yb Α-Sialon

Effects of Technical Parameters on the Phase Composition and Microstructure of Yb Α-Sialon Prepared by Combustion Synthesis

Effect Of Aln Content On The Pressureless Sintering Behaviors Of Sic-Aln Multiphase Ceramics

Fast pressureless sintering of highly transparent AlON ceramics by reducing Y enrichment with nano-sized granular Y 2 O 3 as additive

Phase transformation and growth of rod-like α-SiAlON particles during combustion synthesis

Composition controlled microstructure and mechanical properties of Yb/Lu co-doped SiAlON