Abstract:High-precision microelectromechanical system (MEMS) accelerometers have wide application in the military and civil fields. The closed-loop microaccelerometer interface circuit with switched capacitor topology has a high signal-to-noise ratio, wide bandwidth, good linearity, and easy implementation in complementary metal oxide semiconductor (CMOS) process. Aiming at the urgent need for high-precision MEMS accelerometers in geophones, we carried out relevant research on high-performance closed-loop application specific integrated circuit (ASIC) chips. According to the characteristics of the performance parameters and output signal of MEMS accelerometers used in geophones, a high-precision closed-loop interface ASIC chip based on electrostatic time-multiplexing feedback technology and proportion integration differentiation (PID) feedback control technology was designed and implemented. The interface circuit consisted of a low-noise charge-sensitive amplifier (CSA), a sampling and holding circuit, and a PID feedback circuit. We analyzed and optimized the noise characteristics of the interface circuit and used a capacitance compensation array method to eliminate misalignment of the sensitive element. The correlated double sampling (CDS) technology was used to eliminate low-frequency noise and offset of the interface circuit. The layout design and engineering batch chip were fabricated by a standard 0.35 μm CMOS process. The active area of the chip was 3.2 mm × 3 mm. We tested the performance of the accelerometer system with the following conditions: power dissipation of 7.7 mW with a 5 V power supply and noise density less than 0.5 μg/Hz1/2. The accelerometers had a sensitivity of 1.2 V/g and an input range of ±1.2 g. The nonlinearity was 0.15%, and the bias instability was about 50 μg.

Online Demodulation of Miniatured Capacitive Angular Position Sensor based on ASIC Implementation

A Miniatured Fully Integrated High Resolution and Accuracy Capacitive Angle Encoder

A Front-End Circuit With 16-Channel 12-Bit 100-Ksps Rc-Hybrid Sar Adc For Industrial Monitoring Application

A Fully Integrated Miniatured Capacitive Angle Encoder Based on MEMS Fabrication and ASIC Implementation

A Multi-Parameter Bio-Electric ASIC Sensor with Integrated 2-Wire Data Transmission Protocol for Wearable Healthcare System

An ASIC Solution for Intelligent Electrodes and Active-Cable Used in a Wearable ECG Monitoring System.

An Analog Interface Circuit For Capacitive Angle Encoder Based On A Capacitance Elimination Array And Synchronous Switch Demodulation Method

A Low-Power Digital Processing Circuit for Capacitive Accelerometer

A 1.0 V 78 μw Reconfigurable ASIC Embedded in an Intelligent Electrode for Continuous Remote ECG Applications

An Intelligent and Acceleration ASIC Design for High Precision Positioning and Posture Surveillance System.

Design of Interface ASIC for Capacitive Seismic Sensor with Harmonic Distortion Self-Testing

An Encoding ASIC With Real‐Time Correction for Inductive Angular Sensing Systems

A Novel Time-Multiplexed Fully Differential Interface ASIC With Strong Nonlinear Suppression for MEMS Accelerometers

A High-Performance Interface ASIC for Quartz Rate Sensor

Research on High-Resolution Miniaturized MEMS Accelerometer Interface ASIC

Closed-loop Micro-Accelerometer Based on Capacitive Sensing Interface ASIC

A Digital-Analog Hybrid System-on-Chip for Capacitive Sensor Measurement and Control.

A Novel Single-Excitation Capacitive Angular Position Sensor Design

A Closed-Loop Mems Accelerometer with Capacitive Sensing Interface Asic

Design and Implementation of a System-on-Chip for Self-Calibration of an Angular Position Sensor

An ASIC for Gripper Finger Haptic Force Feedback in Minimally Invasive Surgery