Abstract:High-precision microelectromechanical system (MEMS) accelerometers have wide application in the military and civil fields. The closed-loop microaccelerometer interface circuit with switched capacitor topology has a high signal-to-noise ratio, wide bandwidth, good linearity, and easy implementation in complementary metal oxide semiconductor (CMOS) process. Aiming at the urgent need for high-precision MEMS accelerometers in geophones, we carried out relevant research on high-performance closed-loop application specific integrated circuit (ASIC) chips. According to the characteristics of the performance parameters and output signal of MEMS accelerometers used in geophones, a high-precision closed-loop interface ASIC chip based on electrostatic time-multiplexing feedback technology and proportion integration differentiation (PID) feedback control technology was designed and implemented. The interface circuit consisted of a low-noise charge-sensitive amplifier (CSA), a sampling and holding circuit, and a PID feedback circuit. We analyzed and optimized the noise characteristics of the interface circuit and used a capacitance compensation array method to eliminate misalignment of the sensitive element. The correlated double sampling (CDS) technology was used to eliminate low-frequency noise and offset of the interface circuit. The layout design and engineering batch chip were fabricated by a standard 0.35 μm CMOS process. The active area of the chip was 3.2 mm × 3 mm. We tested the performance of the accelerometer system with the following conditions: power dissipation of 7.7 mW with a 5 V power supply and noise density less than 0.5 μg/Hz1/2. The accelerometers had a sensitivity of 1.2 V/g and an input range of ±1.2 g. The nonlinearity was 0.15%, and the bias instability was about 50 μg.

Design of Interface ASIC for Capacitive Seismic Sensor with Harmonic Distortion Self-Testing

Digital Capacitance Measurement System Based on FPGA

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Research on High-Resolution Miniaturized MEMS Accelerometer Interface ASIC

Online Demodulation of Miniatured Capacitive Angular Position Sensor based on ASIC Implementation

A Novel Time-Multiplexed Fully Differential Interface ASIC With Strong Nonlinear Suppression for MEMS Accelerometers

System-level Simulation and Implementation for a High Q Capacitive Accelerometer with PD Feedback Compensation

A Closed-Loop Mems Accelerometer with Capacitive Sensing Interface Asic

Noise analysis and characterization of a full differential CMOS interface circuit for capacitive closed-loop micro-accelerometer

A High-Voltage Closed-Loop SC Interface for a ± 50 G Capacitive Micro-Accelerometer with 112.4 Db Dynamic Range

An Optical Interferometry Based MEMS Accelerometer Applicable to Seismic-Grade Measurement

A Pseudo-Differential Capacitive MEMS Accelerometer Analog Front-End Design

Closed-loop Micro-Accelerometer Based on Capacitive Sensing Interface ASIC

Flexible capacitive pressure sensor array using acoustic-assisted fabrication of microstructures as surface and dielectric layers

Design, Fabrication and Test of a Low Range Capacitive Accelerometer With Anti-Overload Characteristics

A control and readout circuit with capacitive mismatch auto-compensation for MEMS vibratory gyroscope

A Low-noise High-voltage Interface Circuit for Capacitive MEMS Gyroscope.

Design and Fabrication Research on a Capacitive Accelerometer

Designing of a Micromachined Gyroscope System with a Closed-Loop DC Biased Interface ASIC

An Approach to Accurately Measuring Capacitance with a Distorted Sinusoidal Stimulus Signal

A low-noise fully-differential open-loop interface for high-G capacitive micro-accelerometers with 112.2 dB dynamic range