Abstract:Accurate fault location methods for transmission lines are essential to ensure secure and reliable operation of power systems. Among various fault location approaches, model-based fault location methods are widely adopted in practical power systems since they are compatible with typical data acquisition systems and have clear physical meanings. There are extensive phasor domain and time domain model-based approaches in the existing literature, however, the connections among various line models, as well as corresponding fault location approaches, are not fully investigated. To this end, this paper first systematically reviews transmission line modeling framework for fault location, including time domain and phasor domain matrix/scalar form lumped/distributed parameter models. The relationships between these models are carefully presented and discussed, with clear assumptions for each model. Next, different phasor domain and time domain model-based fault location methods using various line models are shown in detail. Finally, numerical experiments verify the differences between different model-based methods and the importance to use accurate line models for transmission line fault location. The results also clearly indicate the advantages of time domain model-based methods over phasor domain methods: the time domain approaches can accurately locate faults using a short data window within half a cycle after the fault occurs. Compared to traveling wave based methods, the time domain model-based methods are compatible with available data acquisition hardware in substations, with a relatively low sampling rates of several kilo-samples/sec.

A Group of Single-Ended Time-Domain Line Fault Location Methods Using Breaker Operation Information

A novel noniterative single-ended fault location method with distributed parameter model for AC transmission lines

Time-Domain Transmission Line Fault Location Method With Full Consideration of Distributed Parameters and Line Asymmetry

Fault location for general AC/DC transmission lines: Multi-phase, non-homogeneous, partially mutually coupled and multi-terminal lines

Model-based transmission line fault location methods: A review

Time‐domain single‐ended fault location method that does not need remote‐end system information

A Novel Single-Ended Fault Location Method for Locating Double-Phase to Earth Faults

Novel Fault Locating Method Based on Synchronized Voltage Phasor

Improved Fault Location Through Analysis of System Parameters During Autoreclose Operations on Transmission Lines

An Efficient PMU-Based Fault-Location Technique for Multiterminal Transmission Lines

A Two-Terminal Fault Location Algorithm Using Asynchronous Phasors Based on Distributed Parameter Model

Fault Location for HV Three-terminal Transmission Lines

Single-end Fault Location Technique for DC Distribution Lines Based on Network Topology and Measured Traveling Waves

A Physics-Informed Data-Driven Fault Location Method for Transmission Lines Using Single-Ended Measurements with Field Data Validation

Sequential Data-Based Fault Location for Single-Line-to-Ground Fault in a T-Connection Power Line

A Fault Location Algorithm for Multi-Section Combined Transmission Lines Considering Unsynchronized Sampling

Research on a New Single-End Fault Location Method for Single-Phase Grounding Faults of Transmission Lines Through Transition Resistance

Fault Model and Travelling Wave Matching Based Single Terminal Fault Location Algorithm for T-Connection Transmission Line: A Yunnan Power Grid Study

Accurate single terminal fault location algorithm for single-line-to-ground fault in transmission lines with wind farm connection

A Novel Current Travelling Wave Based Single-Ended Fault Location Method for Locating Single-Phase-to-ground Fault of Transmission Line

A non-contact current traveling wave fault location method for multi-terminal overhead power lines based on adaptive mathematical morphology