Abstract:β‐Si3N4 ceramics with an additive oxide system of 1 wt% MgO and 3 wt% Re2O3 (Re = Gd, La, Y and Yb) were fabricated by liquid phase sintering at 1950°C under nitrogen pressure of 748 kPa. Starting α‐Si3N4 powder with 10 vol% rod‐like β‐Si3N4 seed crystallites and an extended sintering time from 5 to 40 h resulted in the formation of bimodal microstructure composed of fine matrix grains and large grains. The 40 h‐sintered specimens of pseudo ternary β‐Si3N4‐MgO‐Gd2O3 system exhibited enhanced thermal conductivity of 127.2 ± 2.5 W m−1 K−1 associated with a degradation of the fracture strength from 1008.0 ± 38.0 to 491.7 ± 32.0 MPa, which was due to the formation of coarse‐grained aggregates that acted as both fracture origin as well as a thermal conductive pathway. The theoretical thermal conductivity was predicted for the sintered specimens by using equations based on a mean‐field micromechanics model to estimate the effective thermal conductivity of each component of binary composites. The calculation results suggested that the thermal conductivity of the large β‐Si3N4 grains (≥ 2 μm in diameter) was relatively high and estimated to be in the range of 175 to 191 Wm−1 K−1.The improved thermal conductivity of the 40 h‐sintered specimens was further discussed for the series of β‐Si3N4‐MgO‐Re2O3 systems based on the nanostructure characterization results obtained by the high‐resolution transmission electron microscopy and scanning transmission electron microscopy‐energy dispersive X‐ray spectrometry analyses. This article is protected by copyright. All rights reserved

Effects of MgO-RE2O3 and SiO2-RE2O3 (RE = La, Nd, Gd, Ho and Lu) Complex Sintering Additives on the Phase Composition, Microstructure and Mechanical Properties of Dual-Phase Si3N4 Ceramics

Effect of Re2O3–MgO additives on the microstructure evolution and properties of β-Si3N4 ceramics

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

The effect of additives on sintering behavior and strength retention in silicon nitride with RE-disilicate

Effect of Rare Earth Additives on Properties of Silicon Nitride Ceramics

The phase transformation behavior of Si3N4 with single Re2O3 (Re = Ce, Nd, Sm, Eu, Gd, Dy, Er, Yb) additive

Effects of Rare-Earth Oxide Additions and Heat-Treatment Temperature on the Transformation and Microstructure of Silicon Nitride

Effect of Er2O3/MgO ratio on mechanical and thermal properties of Si3N4 ceramics

The effects of the single additive on the fabrication of rod-like beta-Si3N4

Effect of rare earths on mechanical properties and microstructures of Si3N4-based ceramics

The Effects of Key Elements Re and Ru on the Phase Morphologies and Microstructure in Ni-based Single Crystal Superalloys

Effect of A-site Substitution on Sintering and Dielectric Properties of ZnO-0.5SiO2 Ceramics

Microstructure and Performance of Silicon Nitride Ceramics with Lu2O3 Additives

Effect of Initial Phase Composition on the Phase Composition, Microstructure, and Mechanical Properties of Si3N4 Ceramics

The Effects of the Single Additive on the Fabrication of Rod-like β-Si3N4

Thermal conductivity improvement in Si3N4 ceramics via grain purification

Influence of ceramic phase content and its morphology on mechanical properties of MgO–C refractories under high temperature nitriding

Effects of sintering additives and sintering methods on the mechanical, antimicrobial and optical properties of Si3N4 bioceramics

The influence of magnesium compounds on the properties of silicon nitride ceramics

Investigations on the mechanical and thermal properties of multicomponent dual-phase rare-earth zirconate ceramics

Oxidation behavior and mechanical property of Si3N4 ceramics with rare earth oxide addition