Abstract:Gas-solid-liquid multiphase flow systems have been widely applied in energy engineering, petrochemical industries, biochemical industries and food industries, etc ., which usually involve multi-physical processes and multi-reaction stages. As a typical gas-solid-liquid multiphase flow system, the semi-dry flue gas desulfurization fluidized bed has been widely applied by small and medium-scale thermal power plants for its advantages of excellent mixing effect, relatively high efficiency and low cost. This study focused on the fluid hydrodynamics, wet particle motions and the transfer efficiency (SO 2 removal efficiency) in a fluidized bed via two-way coupled CFD-DEM numerical simulations with the implementation of different semi-dry desulfurization stages ("constant-rate" absorption stage, "falling-rate" absorption stage and solid absorption stage) as well as the liquid bridge force. To avoid the fast evaporation of small droplets, simulations based on larger particles (Geldart group D) were also conducted to clarify the influence of varying liquid volume contents. Results revealed that the existence of liquid layers would partly enhance the desulfurization efficiency, while in this case the bed exhibits poor fluidization characteristics. Adding humification water in the solid absorption stage would transform the reaction stage from solid absorption stage to "constant-rate" absorption stage, which improves the desulfurization efficiency significantly. It could also be summarized that the increase of Ca/S molar ratio would enhance the desulfurization efficiency partly, but the improvement would not be obvious when the Ca/S molar ratio is greater than a certain range.

Investigation on the Bed Material of Circulating Fluidized Bed Flue Gas Desulfurization by a Scanning Electron Microscope

1001-6929(2001)03-0059-03

Modeling on circulating fluidized bed flue gas desulfurization

Mechanism of Dry Fgd Process and Characters of Circulating Particles

Influence of Chemical and Thermodynamic Parameters on the Flue Gas Desulphurization Efficiency in a Circulating Fluidized Bed

Experimental Study On Medium Temperature Dry Flue Gas Desulphurization By Using Active Sorbent In Circulating Fludized Bed

Mass Equilibrium of Gas Desulfurization Bed Materials in a Circulating Fluidized Bed and the Variation of Chemical Composition

Experiment and Mechanism Analysis of Desulfurization with a MgO-Based Desulfurizer Fixed Bed Method

Investigation on Removal Effects and Condensation Characteristics of Condensable Particulate Matter: Field Test and Experimental Study.

Experimental Study of Semi-dry Flue Gas Desulfurization in Circulating Suspension Fluidized Bed

Combustion process in fluidized bed and agglomeration microstructure analysis for sludge

D306 EXPERIMENTS AND MATHEMATICAL MODEL ON FLUE GAS DESULFURIZATION OF CIRCULATING FLUIDIZED BED

Particularities Concerning Sintered Ash Deposits along Flue Ways of CFB Waste Incinerators

Experiment of Optimizing Gas-Particle Flow Regime in the Square-section Circulating Suspension Bed

The Characterization of Sintering Deposit on the Heat-Transfer Surface of CFB Municipal Solid Waste Incinerator

Research on the Emissions of Harmful Gas in Fluidized Bed During MSW Combustion

Study on the distributed pore characteristic of dry flue gas desulfurization

Dominant influence parameters on the FGD efficiency and desulfurization mechanism in circulating fluidized bed in ambient temperature

Experimental and model investigation on the mass balance of a dry circulating fluidized bed for flue gas desulfurization system

CFD-DEM simulations of a gas-solid-liquid fluidization system: Effects on the flow field and particle behavior of semi-dry desulfurization fluidized bed

High-Temperature Sulfur Removal Under Fluidized-Bed Combustion Conditions - A Chemical Interpretation