Abstract:Gas-solid-liquid multiphase flow systems have been widely applied in energy engineering, petrochemical industries, biochemical industries and food industries, etc ., which usually involve multi-physical processes and multi-reaction stages. As a typical gas-solid-liquid multiphase flow system, the semi-dry flue gas desulfurization fluidized bed has been widely applied by small and medium-scale thermal power plants for its advantages of excellent mixing effect, relatively high efficiency and low cost. This study focused on the fluid hydrodynamics, wet particle motions and the transfer efficiency (SO 2 removal efficiency) in a fluidized bed via two-way coupled CFD-DEM numerical simulations with the implementation of different semi-dry desulfurization stages ("constant-rate" absorption stage, "falling-rate" absorption stage and solid absorption stage) as well as the liquid bridge force. To avoid the fast evaporation of small droplets, simulations based on larger particles (Geldart group D) were also conducted to clarify the influence of varying liquid volume contents. Results revealed that the existence of liquid layers would partly enhance the desulfurization efficiency, while in this case the bed exhibits poor fluidization characteristics. Adding humification water in the solid absorption stage would transform the reaction stage from solid absorption stage to "constant-rate" absorption stage, which improves the desulfurization efficiency significantly. It could also be summarized that the increase of Ca/S molar ratio would enhance the desulfurization efficiency partly, but the improvement would not be obvious when the Ca/S molar ratio is greater than a certain range.

Influence of Chemical and Thermodynamic Parameters on the Flue Gas Desulphurization Efficiency in a Circulating Fluidized Bed

Dominant influence parameters on the FGD efficiency and desulfurization mechanism in circulating fluidized bed in ambient temperature

Modeling on circulating fluidized bed flue gas desulfurization

Experimental Study On Medium Temperature Dry Flue Gas Desulphurization By Using Active Sorbent In Circulating Fludized Bed

Effect of operating parameters and reactor structure on moderate temperature dry desulfurization.

D306 EXPERIMENTS AND MATHEMATICAL MODEL ON FLUE GAS DESULFURIZATION OF CIRCULATING FLUIDIZED BED

Experimental Study of Semi-dry Flue Gas Desulfurization in Circulating Suspension Fluidized Bed

Mass Equilibrium of Gas Desulfurization Bed Materials in a Circulating Fluidized Bed and the Variation of Chemical Composition

Slurry Evaporation of Flue Gas Desulphurization System in Circulating Fluidized Bed

Application research on high efficiency desulfurization technology of reducing calcium-sulfur ratio in circulating fluidized bed boiler

CFD-DEM simulations of a gas-solid-liquid fluidization system: Effects on the flow field and particle behavior of semi-dry desulfurization fluidized bed

Experiment of Optimizing Gas-Particle Flow Regime in the Square-section Circulating Suspension Bed

Analysis and Optimization of Chemical Processing Parameters for Wet Flue Gas Desulphurization System

Dry Desulfurization in a Circulating Fluidized Bed (CFB) with Chain Reactions at Moderate Temperatures

1001-6929(2001)03-0059-03

The Fundamental Studies on Combustion of Sintering Flue Gas in Circulating Fluidized Bed

Study on Spray Condensation Performance of Desulfurization Wet Flue Gas

Numerical Simulation of Moderate Temperature Desulfurization in Circulating Fluidized Bed Reactor Considering Sorbent Abrasion

Experimental study on influence of multi-stage humidification on semi-dry flue gas desulfurization

Analyze the Desulfurization Efficiency of Circulatory Fluidized bed(CFB)Boiler and Monitoring Cases

Experimental and model investigation on the mass balance of a dry circulating fluidized bed for flue gas desulfurization system