Abstract:This paper reports a novel oscillation control algorithm for MEMS vibratory gyroscopes using a modified electromechanical amplitude modulation (MEAM) technique, which enhances the robustness against the frequency variation of the driving mode, compared to the conventional EAM (CEAM) scheme. In this approach, the carrier voltage exerted on the proof mass is frequency-modulated by the drive resonant frequency. Accordingly, the pick-up signal from the interface circuit involves a constant-frequency component that contains the amplitude and phase information of the vibration displacement. In other words, this informational detection signal is independent of the mechanical resonant frequency, which varies due to different batches, imprecise micro-fabrication and changing environmental temperature. In this paper, the automatic gain control loop together with the phase-locked loop are simultaneously analyzed using the averaging method and Routh–Hurwitz criterion, deriving the stability condition and the parameter optimization rules of the transient response. Then, a simulation model based on the real system is set up to evaluate the control algorithm. Further, the proposed MEAM method is tested using a field-programmable-gate-array based digital platform on a capacitive vibratory gyroscope. By optimizing the control parameters, the transient response of the drive amplitude reveals a settling time of 45.2 ms without overshoot, according well with the theoretical prediction and simulation results. The first measurement results show that the amplitude variance of the drive displacement is 12 ppm in an hour while the phase standard deviation is as low as 0.0004°. The mode-split gyroscope operating under atmospheric pressure demonstrates an outstanding performance. By virtue of the proposed MEAM method, the bias instability and angle random walk are measured to be 0.9° h−1 (improved by 2.4 times compared to the CEAM method) and 0.068° (√h)−1 (improved by 1.4 times), respectively.

Digital Fast Startup Procedure for Micro-Machined Vibratory Gyroscopes Using Optimized Fuzzy Control Strategy

Fast self-resonant startup procedure for digital MEMS gyroscope system.

Constant-frequency Oscillation Control for Vibratory Micro-Machined Gyroscopes

MEMS gyroscopes parametric excitation control scheme with constant resonant frequency

Drive Mode Control for MEMS Gyroscopes with Electrostatically Tunable Structure

Performance Improvement for MEMS Gyroscopes by Suppressing the Circuit Phase Delay

A Digital Control Structure for Lissajous Frequency-Modulated Mode MEMS Gyroscope

A Sub-0.1°/H Bias-Instability MEMS Gyroscope Using Resonant Constant-Frequency Driving Technique

Rapid start-up control of high Q-factor MEMS gyroscope

Design and Test of MEMS Gyroscope Control System Based on LMSD

A 0.09°/h Bias-Instability MEMS Gyroscope Working with a Fixed Resonance Frequency

Identification and Suppression of Driving Force Misalignment Angle for a MEMS Gyroscope Using Parametric Excitation

One-time Frequency Sweep to Eliminate IQ Coupling in MEMS Vibratory Gyroscopes

Noise Analysis and Modeling for a Digital Control Architecture for Lissajous Frequency-Modulated MEMS Gyroscope with Amplitude-Modulated Readout

A novel oscillation control for MEMS vibratory gyroscopes using a modified electromechanical amplitude modulation technique

Effective Bias Warm-Up Time Reduction for MEMS Gyroscopes Based on Active Suppression of the Coupling Stiffness

Digital Control and Performance Test of a Symmetrical Doubly Decoupled Micro-Machined Gyroscope

A Temperature Drift Suppression Method of Mode-Matched MEMS Gyroscope Based on a Combination of Mode Reversal and Multiple Regression

A Temperature Control System Used for Improving Resonant Frequency Drift of MEMS Gyroscopes.

Transient response and stability of the AGC-PI closed-loop controlled MEMS vibratory gyroscopes

A Digital Interface ASIC for Triple-Axis MEMS Vibratory Gyroscopes