Abstract:Introduction of structural modification and novel transduction materials to nanomechanical cantilever (NMC) sensor can bring considerable improvement in sensor performance leading to ultra-sensitive nanomechanical sensor platforms. This work reports development of an optimized and highly sensitive silicon MEMS Nanomechanical Membrane-Flexure (NMF) piezoresistive surface stress sensor. This MEMS structure consists of a circular adsorbate membrane suspended by four inverse trapezoidal flexures. The electromechanical transduction of the sensor is performed by integrating a high gauge factor low temperature sputter deposited Indium Tin Oxide (ITO) thin film as piezoresistor. The ITO thin film was experimentally characterized for extracting its electrical, mechanical, and electromechanical properties to assess its candidature in integrating as strain sensing element with nanomechanical sensors. The gauge factor of ITO thin film was measured using a high precision four-point bending fixture experimental setup. An ultra-thin ITO film deposited at room temperature with no oxygen flow and post annealing treatments exhibited a high negative gauge factor of −430, making it an excellent candidate in nanomechanical sensor platform. The incorporation of sputter deposited ITO thin film as piezoresistive layer obviated the need for doping in silicon which further reduced the fabrication process complexity for NMF sensor. The NMF sensor fabrication following SOI based silicon MEMS process along with device characterization have also been carried out as part of this work. The optimized design of piezoresistive NMF sensor exhibited an improved surface stress sensitivity of nearly 15 times higher than conventional cantilever sensor and thereby opening new possibilities in bio-chemical and environmental sensing applications. [2021-0127]

TRANSDUCERS '03. 12th International Conference on Solid-State Sensors, Actuators and Microsystems. Digest of Technical Papers (cat. No.03TH8664)

Polymer Mems-Based Fabry-Perot Shear Stress Sensor

A High Sensitive Fabry-Perot Shear Stress Sensor Employing Flexible Membrane and Double SU-8 Structures

A Novel Transparent Dielectric Elastomer Sensor for Compressive Force Measurements

Highly Sensitive Lateral Deformable Optical MEMS Displacement Sensor: Anomalous Diffraction Studied by Rigorous Coupled-Wave Analysis.

Design, Fabrication And Measurement Of Tan Thin Film Resistor Based On Mems Technology

High-sensitivity strain sensor based on an asymmetric tapered air microbubble Fabry-Pérot interferometer with an ultrathin wall

A hybrid polymer/ceramic/semiconductor fabrication platform for high-sensitivity fluid-compatible MEMS devices with sealed integrated electronics

A Multipurpose Optical MEMS Sensor for Harsh Environments

A Simple Method To Implement And Further Performances Enhancement Of The Shear Force Sensor

High Sensitivity, Low Temperature-Crosstalk Strain Sensor Based on a Microsphere Embedded Fabry–Perot Interferometer

Flexible and Transparent Surface Acoustic Wave Microsensors and Microfluidics

High-sensitivity Strain Sensor with an In-Fiber Air-Bubble Fabry-Perot Interferometer

A Microfluidic Sensor for Dynamic Surface Tension Measurement

Integrated Piezoresistive Normal Force Sensors Fabricated Using Transfer Processes with Stiction Effect Temporary Handling

An MEMS Optical Fiber Pressure Sensor Based on a Square Silicon Diaphragm: Numerical Simulation and Experimental Verification

Silicon MEMS Nanomechanical Membrane Flexure Sensor With Integrated High Gauge Factor ITO

A Hybrid Two-Axis Force Sensor for the Mesoscopic Structural Superlubricity Studies

Design and Manufacture of a High Precision MEMS Flexible Force Sensor

MEMS pressure sensor based on optical Fabry–Perot interference

Laser Self-Mixing Sensor for Simultaneous Measurement of Young’s Modulus and Internal Friction (Invited)