Abstract:With the rapid development of information technology, high-speed digital optical signal transmission technology has become the core of modern communication networks. However, the increase in transmission rates brings challenges such as noise, distortion, and interference, which affect the accuracy of clock recovery. To address these issues, this study proposes a clock recovery algorithm based on the eye diagram opening area to improve the accuracy and efficiency of high-speed digital optical signal jitter measurement. The proposed method extracts clock information from the signal using the opening area and curvature characteristics of the eye diagram for jitter measurement. Experimental results demonstrate that the clock recovery algorithm based on the eye diagram opening area can stably reconstruct the signal eye diagram and obtain jitter parameters under different optical power conditions. At optical powers of -7.2 dBm, -12.2 dBm, and -17.2 dBm, the Q-factors were 8.8, 7.6, and 4.3, respectively, and the RMS jitter values were 12.2 ps, 13.4 ps, and 21.2 ps, respectively. At optical powers of -2.3 dBm, 0.1 dBm, 2.4 dBm, 4.6 dBm, and 6.0 dBm, the Q-factors were 9.1, 9.3, 9.5, 9.7, and 10.0, respectively, and the average jitter values were 8.9 ps, 8.5 ps, 8.0 ps, 7.5 ps, and 7.0 ps. These results indicate that the proposed algorithm performs excellently under low optical power conditions and maintains high recovery accuracy even when jitter increases at higher optical powers. The clock recovery algorithm based on the eye diagram opening area significantly improves the accuracy and stability of high-speed digital optical signal jitter measurement, enriches the theoretical research of clock recovery algorithms, and shows significant advantages in improving signal transmission quality, reducing bit error rate, and enhancing communication link reliability. The research outcomes provide key technical support for the optimization of modern high-speed optical communication systems.

An Improved Clock Cycle Measurement Method for High-Speed Serial Signal with Duty-Cycle-Distortion Jitter

A novel high-accuracy clock stabilizer with 50% duty cycle

A Novel Multiphase Clock Generator Based on Digital DLL Designed for Oversampling in Transceiver

A Software PAM4 Clock Data Recovery Algorithm for High‐speed Serial Communication

180.5mbps-8gbps Dll-Based Clock And Data Recovery Circuit With Low Jitter Performance

A Clock Calibration Method for an All-Digital Burst-Mode CDR with Embedded TDC

A statistical jitter tolerance estimation applied for clock and data recovery using oversampling

A 6.25Gb/s CMOS clock and data recovery DLL with anti-harmonic lock

A 4-to-10.5 Gb/s Continuous-Rate Digital Clock and Data Recovery With Automatic Frequency Acquisition

A 3.125gbit/s CMOS Clock and Data Recovery Circuit

A 0.2–7.1-Gb/s Low-Jitter Full-Rate Reference-Less CDR for Communication Signal Analyzers

A High Precision and Low Power Digital Synchronous Clock for Sensor Network

A Novel Clock and Data Recovery Technique Based on Sigma-Delta Phase Quantization

A Novel Clock And Data Recovery Scheme Based On Sigma-Delta Quantization

A speculative clock and data recovery architecture for multi-gigabit/s series links

An improved 40 Gb/s CDR with jitter-suppression filters and phase-compensating interpolators

A Reference-Less All-Digital Burst-Mode CDR with Embedded TDC.

Research on high-speed digital optical signal jitter measurement technology based on clock recovery algorithm using eye diagram opening area

Delay‐locked Loop Based Clock and Data Recovery with Wide Operating Range and Low Jitter in a 65‐nm CMOS Process

Evaluation of a Subnanosecond Clock and Data Recovery Technique Via Matlab Simulink and Opti-System Co-Simulation

A 25gbps, 2X-Oversampling Cdr Using A Zero-Crossing Linearizing Phase Detector