Abstract:A strategic option for the production of H2 from renewable resources is use of the ethanol steam reforming reaction. Catalysts based on nickel have been widely investigated for this reaction, offering the advantages of low cost and high activity. However, a difficulty is that nickel may be strongly deactivated by coke formation. Perovskite-type mixed oxides are promising precursors for nickel-based catalysts, since their reduction leads to the formation of highly dispersed metal particles that can mitigate carbon deposition. However, high calcination temperatures are required for perovskite structure formation, resulting in low surface areas and limiting the effectiveness of this method. In order to address this difficulty, the present work proposes a novel strategy whereby the perovskite-type oxide LaNiO3 is supported on SBA-15. Characterization of the catalysts was performed using XRF, XRD, SEM, TPR, TEM, BET, H2-TPD, and TGA techniques. Their performances were then evaluated in catalysis of the ethanol steam reforming reaction to produce hydrogen. Calcination at 750 °C resulted in formation of highly dispersed perovskite on a support that presented high specific surface area. The catalyst obtained from reduced LaNiO3/SBA-15 with 33 wt% perovskite was the most active in the reaction. Analyses using TGA and SEM showed the formation of carbon mainly over Ni catalysts obtained from bulk LaNiO3 perovskite, while supporting LaNiO3 on SBA-15 led to lower deposition of carbon. The superior performance of this material in catalysis could be attributed to the dispersion of the perovskite on SBA-15, resulting in smaller size of the Ni metal particles formed during the reduction, compared to the catalyst derived from bulk perovskite. This promising method could be used in the production of a wide range of other catalysts.

Ni-hydrocalumite Derived Catalysts for Ethanol Steam Reforming on Hydrogen Production

Magnesium Promoted Hydrocalumite Derived Nickel Catalysts for Ethanol Steam Reforming

Hydrogen Production from Ethanol Steam Reforming over Ni/Al2O3 and Ni/La2O3 Catalysts at Low Temperature

Effect of Nickel Loading on the Production of Hydrogen Via Ethanol Steam Reforming

Catalysts Research for Hydrogen Production from Steam Reforming of Ethanol over Ni-Fe/γ-Al2O3

Hydrogen production from ethanol steam reforming over nickel based catalyst derived from Ni/Mg/Al hydrotalcite-like compounds

Hydrogen Production by Ethanol Steam Reforming on Nicumgal Catalysts Derived from Hydrotalcite-Like Precursors

Studies on Ni/Al2O3 Catalyst for Hydrogen Production from Ethanol Steam Reforming

Hydrogen Production by Ethanol Steam Reforming over Ni/Sba-15 Mesoporous Catalysts: Effect of Au Addition

Effect of Ca and Co over Ni–Al Mixed Oxides for Hydrogen Production by Ethanol Steam Reforming

Improving Coking Resistance and Catalytic Performance of Ni Catalyst from LaNiO3 Perovskite by Dispersion on SBA-15 Mesoporous Silica for Hydrogen Production by Steam Reforming of Ethanol

Ethanol Steam Reforming over Ni-Cu/Al2O3-MyOz (M = Si, La, Mg, and Zn) Catalysts

Ni/SBA-15 Catalysts for Hydrogen Production by Ethanol Steam Reforming: Effect of Nickel Precursor

A-site Deficient Titanate Perovskite Surface with Exsolved Nickel Nanoparticles for Ethanol Steam Reforming

Nanoarchitectured Ni-ZrO 2 catalysts for hydrogen production from steam reforming of ethanol

High Performance Ni Exsolved and Cu Added La0.8Ce0.2Mn0.6Ni0.4O3-based Perovskites for Ethanol Steam Reforming

From Steam Reforming of Ethanol at Low Temperature over , and Catalysts for Fuel-Cell Application

Hydrogen Production Via Steam Reforming of Ethanol on Phyllosilicate-Derived Ni/SiO2: Enhanced Metal–Support Interaction and Catalytic Stability

Hydrogen Production from Steam Reforming of Ethanol Using Ni/CeO2 and Ni-Cu/CeO2 Catalysts

Investigation of Ni/SiO2 Catalysts Prepared at Different Conditions for Hydrogen Production from Ethanol Steam Reforming

Hydrogen production by ethanol steam reforming over Ni–Co–Al mixed oxides derived from LDH