Abstract:A strategic option for the production of H2 from renewable resources is use of the ethanol steam reforming reaction. Catalysts based on nickel have been widely investigated for this reaction, offering the advantages of low cost and high activity. However, a difficulty is that nickel may be strongly deactivated by coke formation. Perovskite-type mixed oxides are promising precursors for nickel-based catalysts, since their reduction leads to the formation of highly dispersed metal particles that can mitigate carbon deposition. However, high calcination temperatures are required for perovskite structure formation, resulting in low surface areas and limiting the effectiveness of this method. In order to address this difficulty, the present work proposes a novel strategy whereby the perovskite-type oxide LaNiO3 is supported on SBA-15. Characterization of the catalysts was performed using XRF, XRD, SEM, TPR, TEM, BET, H2-TPD, and TGA techniques. Their performances were then evaluated in catalysis of the ethanol steam reforming reaction to produce hydrogen. Calcination at 750 °C resulted in formation of highly dispersed perovskite on a support that presented high specific surface area. The catalyst obtained from reduced LaNiO3/SBA-15 with 33 wt% perovskite was the most active in the reaction. Analyses using TGA and SEM showed the formation of carbon mainly over Ni catalysts obtained from bulk LaNiO3 perovskite, while supporting LaNiO3 on SBA-15 led to lower deposition of carbon. The superior performance of this material in catalysis could be attributed to the dispersion of the perovskite on SBA-15, resulting in smaller size of the Ni metal particles formed during the reduction, compared to the catalyst derived from bulk perovskite. This promising method could be used in the production of a wide range of other catalysts.

Hydrogen Production from Ethanol Steam Reforming over Ni/Al2O3 and Ni/La2O3 Catalysts at Low Temperature

From Steam Reforming of Ethanol at Low Temperature over , and Catalysts for Fuel-Cell Application

Studies on Ni/Al2O3 Catalyst for Hydrogen Production from Ethanol Steam Reforming

Hydrogen from steam reforming of ethanol in low and middle temperature range for fuel cell application

Influence of Preparation Conditions of Ni/Al_2O_3 Catalyst on Its Activity in ydrogen Production by Ethanol Steam Reforming

Efficient Hydrogen Production from Ethanol Steam Reforming over La-modified Ordered Mesoporous Ni-based Catalysts

Ni-hydrocalumite Derived Catalysts for Ethanol Steam Reforming on Hydrogen Production

Hydrogen Production from Steam Reforming of Ethanol Using Ni/CeO2 and Ni-Cu/CeO2 Catalysts

Steam reforming of ethanol for hydrogen production: influence of catalyst composition (Ni/Al2O3, Ni/Al2O3–CeO2, Ni/Al2O3–ZnO) and process conditions

Hydrogen Production by Steam Reforming of Ethanol over Flowerlike Micro Spheres NiO/La2O3 Catalyst

Steam reforming of ethanol for hydrogen production over NiO/ZnO/ZrO2 catalysts

Ni-based catalysts supported on La/AlZn/AlLa oxides for hydrogen production via glycerol steam reforming

Hydrogen production by ethanol steam reforming over Ni–Co–Al mixed oxides derived from LDH

Effect of Ca and Co over Ni–Al Mixed Oxides for Hydrogen Production by Ethanol Steam Reforming

Hydrogen production by aqueous phase reforming over stable La-promoted Ni-based hydrotalcite catalysts

Steam reforming of ethanol over Ni/MgAl2O4 catalysts

Improving Coking Resistance and Catalytic Performance of Ni Catalyst from LaNiO3 Perovskite by Dispersion on SBA-15 Mesoporous Silica for Hydrogen Production by Steam Reforming of Ethanol

A Comparative Research on the Catalytic Activity of La2O3 and Γ-Al2o3 Supported Catalysts for Acetic Acid Steam Reforming

Role of Fe Species of Ni-Based Catalysts for Efficient Low-Temperature Ethanol Steam Reforming

Hydrogen production from ethanol by steam reforming with recyclable NiCaO x /NaCl catalysts

Catalytic Steam Reforming of Ethanol for Hydrogen Production over Ni/Ceo2-Zro2 Catalysts