Abstract:Due to the pristine interface of the 2D/3D face-tunneling heterostructure with an ultra-sharp doping profile, the 2D/3D tunneling field-effect transistor (TFET) is considered as one of the most promising low-power devices that can simultane-ously obtain low off-state current (IOFF), high on-state current (ION) and steep subthreshold swing (SS). As a key element for the 2D/3D TFET, the intensive exploration of the tunnel diode based on the 2D/3D heterostructure is in urgent need. The transfer technique composed of the exfoliation and the release process is currently the most common approach to fabri-cating the 2D/3D heterostructures. However, the well-established transfer technique of the 2D materials is still unavailable. Only a small part of the irregular films can usually be obtained by mechanical exfoliation, while the choice of the chemical exfoliation may lead to the contamination of the 2D material films by the ions in the chemical etchants. Moreover, the defor-mation of the 2D material in the transfer process due to its soft nature also leads to the nonuniformity of the transferred film, which is one of the main reasons for the presence of the wrinkles and the stacks in the transferred film. Thus, the large-scale fabrication of the high-quality 2D/3D tunnel diodes is limited. In this article, a comprehensive transfer technique that can mend up the shortages mentioned above with the aid of the water and the thermal release tape (TRT) is proposed. Based on the method we proposed, the MoS2/Si tunnel diode is experimentally demonstrated and the transferred monolayer MoS2 film with the relatively high crystal quality is confirmed by atomic force microscopy (AFM), scanning electron microscopy (SEM), and Raman characterizations. Besides, the prominent negative differential resistance (NDR) effect is observed at room temperature, which verifies the relatively high quality of the MoS2/Si heterojunction. The bilayer MoS2/Si tunnel diode is also experimentally fabricated by repeating the transfer process we proposed, followed by the specific analysis of the electrical characteristics. This study shows the advantages of the transfer technique we proposed and indicates the great application foreground of the fabricated 2D/3D heterostructure for ultralow-power tunneling devices.

Rail-to-Rail MoS2 Inverters

Integrated Circuits Based on Bilayer MoS2 Transistors

High-Performance MoS 2 Complementary Inverter Prepared by Oxygen Plasma Doping

High-performance Heterogeneous Complementary Inverters Based on N-Channel MoS2 and P-Channel SWCNT Transistors

Defect-Engineered Atomically Thin MoS<sub>2</sub> Homogeneous Electronics for Logic Inverters

Low-power-consumption CMOS Inverter Array Based on CVD-grown P-Mote2 and N-Mos2

Symmetric Complementary Logic Inverter Using Integrated Black Phosphorus and MoS2 Transistors

MoS2/Si Tunnel Diodes Based on Comprehensive Transfer Technique

Hybrid Complementary Metal-Oxide-Semiconductor Inverters Based on Single Nanowires

Ultra-Steep-Slope High-Gain MoS2 Transistors with Atomic Threshold-Switching Gate

On-Chip Integrated High Gain Complementary MoS2 Inverter Circuit with Exceptional High Hole Current P-Channel Field-Effect Transistors

Scaling of MoS 2 Transistors and Inverters to Sub-10 nm Channel Length with High Performance

High-Performance CMOS Inverter Array with Monolithic 3D Architecture Based on CVD-Grown N-Mos2 and P-Mote2.

Static and Dynamic Performance of Complementary Inverters Based on Nanosheet α-MoTe2 p-Channel and MoS2 n-Channel Transistors

Flexible Complementary Metal‐Oxide‐Semiconductor Inverter Based on 2D p‐type WSe2 and n‐type MoS2

Scaling of MoS2 Transistors and Inverters to Sub-10 Nm Channel Length with High Performance

High‐Performance CMOS Inverter Array with Monolithic 3D Architecture Based on CVD‐Grown n‐MoS 2 and p‐MoTe 2

Two-Dimensional SnSe2(1- x)S2 x/MoTe2 Antiambipolar Transistors with Composition Modulation for Multivalued Inverters

High Rectification Ratio Metal-Insulator-semiconductor Tunnel Diode Based on Single-Layer MoS2

Realization of Extremely High-Gain and Low-Power in nMOS Inverter Based on Monolayer WS2 Transistor Operating in Subthreshold Regime

Two-Dimensional Inverters Based on MoS<sub>2</sub>-hBN-Graphene Heterostructures Enabled by a Layer-by-Layer Dry-Transfer Method