Inclusion-Based Model: Calculating Tooth Root Bending Strength Considering Steel Cleanliness

Christian Eggert,Dieter Mevissen,Christian Westphal,Christian Brecher

DOI: https://doi.org/10.3390/met14121349

IF: 2.695

2024-11-28

Metals

Abstract:Current gear design guidelines and standards have given little or no consideration to the increase in strength that can be achieved by using ultra-clean steels. In order to fully exploit the potential of ultra-clean steels, it is therefore necessary to use higher-quality calculation methods that combine FEM stress calculations with local strength calculations. Therefore, the aim of this paper is to extend the inclusion-based model to allow for the calculation of the tooth root bending strength of gears with different steel cleanliness. For this purpose, a material analysis of 20MnCr5 with three different degrees of cleanliness is carried out and the respective material defect distribution is determined. In order to be able to represent the determined material defect distributions of the different cleanliness grades in the inclusion-based model, the model is extended accordingly, and a sensitivity analysis is carried out on the influence of the material defect distribution functions on the tooth root bending strength calculation. Finally, the model is applied to a pulsator test to verify the applicability of the model. The results of the verification show that the calculation of the mean bending strength of gears in pulsator investigations is generally possible with the extended inclusion-based model. The inclusion-based model thus offers the potential to improve the statistical significance of pulsator test results by supplementing the limited number of practical test points with the virtual test points of the inclusion-based model.

materials science, multidisciplinary,metallurgy & metallurgical engineering