Abstract:A numerical model for determination the gear tooth root fatigue behaviour is presented. Two cases are being explored, first in which gear tooth was loaded with normal pulsating force acting at the highest point of single tooth contact, and second in which the fact that in actual gear operation the magnitude as well as the position of the force changes as the gear rotates through the mesh is taken into account. The fatigue process leading to tooth breakage is divided into crack initiation and crack propagation period. The critical plane damage model has been used to determine the number of stress cycles required for the fatigue crack initiation. The critical plane methods predict not only fatigue crack initiation life, but also the initiated crack direction, which makes a good starting point for further fatigue crack propagation studies. Finite element method and linear elastic fracture mechanics theories are then used for the further simulation of the fatigue crack growth under a moving load. Moving load produces a non-proportional load history in a gear's tooth root. Consequently, the maximum tangential stress theory will predict a unique kink angle for each load increment, but herein crack’ s trajectory is computed at the end of the load cycle. An approach that accounts for fatigue crack closure effects is developed to propagate crack under non-proportional load. The total number of stress cycles for the final failure to occur is then a sum of stress cycles required for the fatigue crack initiation and number of loading cycles for crack propagation from the initial to the critical length. Although some influences (non-homogeneous material, traveling of dislocations, etc.) were not taken into account in the computational simulations, the presented model seems to be very suitable for determination of service life of gears because numerical procedures used here are much faster and cheaper if compared with the experimental testing.

Fatigue Behavior of Gear Tooth root under Moving Load

Gear Tooth Root Crack Path and Fatigue Life

Gear Tooth Root Fatigue Behaviour

An Experimental Study on the Accuracy of Cumulative Damage Models in Gear Tooth Bending Fatigue

Numerical Modelling of Gear Tooth Root Fatigue Behaviour

Analysis of Tooth Root Crack Initiation, Propagation and Fracture Surface Based on Gear Bending Fatigue Test

Gear fatigue crack prognosis using embedded model, gear dynamic model and fracture mechanics

Effect of Initial Crack Position on Crack Propagation Behaviors of Heavy-Duty Transmission Gear

A numerical model for total bending fatigue life estimation of carburized spur gears considering the hardness gradient and residual stress

Improved analytical model for mesh stiffness calculation of cracked helical gear considering interactions between neighboring teeth

Crack growth based tooth root life prediction model—an influence quantity analysis

Contact fatigue life prediction of a bevel gear under spectrum loading

On the usage of pulsator data within the load spectra assessment of gears

Dynamic Characteristics of Gear System Under Compound Fault of Tooth Root Crack and Bearing Outer Ring

Application of the Thin Slice Model for Determination of Face Load Distribution along the Line of Contact and the Relative Load Distribution Measured along Gear Root

Investigation of Crack Propagation Behaviour in Thin-Rim Gears: Experimental Tests and Numerical Simulations

Research on Root Strain Response Characteristics of Inner Ring of Planetary Gear Transmission System with Crack Fault

Research on Problems of Fracture Mechanics about the Spur Gears with Cracked Tooth

Loaded Tooth Contact Analysis and Meshing Stiffness Calculation for Cracked Spiral Bevel Gears

Dynamic Simulation of Planetary Gearbox With Tooth Root Crack Based on a Rigid-Flexible Coupled Model

Analysis of Gear Crack’s Influence on Mesh Stiffness